86 street/strip camaro for sale
#1
Member
Thread Starter
iTrader: (2)
Join Date: Aug 2005
Location: Columbus, GA
Posts: 315
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1986 IROC Z28
Engine: 350 carbed
Transmission: TH350
Axle/Gears: 3.43
86 street/strip camaro for sale
Like it says, I'm selling my baby. I'm located in Columbus, GA.
parts:
Weld draglite wheels
MSD ignition system
TH350 tranny w/ trans brake by art carr
Hurst promatic ratchet shifter
MSD digital window switch (part of nitrous system nitrous)
NOS sniper nitrous kit with 125 and 150 jets
pressure activated bottle heater
NOS hi-flow bottle valve
remote nitrous bottle open/close solenoid with pressure gauge
secondary fuel cell and fuel pump for nitrous
(nitrous system is custom done with complete safety in mind)
holley 750 vacuum secondary with proform main body
Older Holley scorpion intake manifold
ported aluminum 58cc vette heads
heat wrapped hedman 1 5/8 headers (open up where y pipe would be)
comp cams magnum hyrdaulic flat tappet cam with 244int./244exh. at .050 inch lift
steel 1.6 roller tip rockers
march pulley kit
proform electric water pump
Intrax lowering spring
UMI subframe connectors
UMI LCA relocation brackets
summit racing drive shaft safety loop
Competition engineering 10 point roll cage
RCI 5-point harness
summit high back poly seat w/ leather cover
The interior is gutted except for the center console and the dash. The floor has been coated with a rubberizer. I have not installed the passenger seat that I purchased. If you want it installed I have no problem doing so. It is the same seat/cover combo as the drivers seat. I will install the matching 5-point harness if you want the seat intalled. The engine was completely disassembled and rebuilt a year and a half ago. It has seen only one strip pass and about 400 road miles from driving to the track and to work to show it off . All lights functional except for left turn signal (have not checked but believe to be just bulbs). Rear hatch motor is still fully operational as is the power steering and the power brake (disc all around)
parts:
Weld draglite wheels
MSD ignition system
TH350 tranny w/ trans brake by art carr
Hurst promatic ratchet shifter
MSD digital window switch (part of nitrous system nitrous)
NOS sniper nitrous kit with 125 and 150 jets
pressure activated bottle heater
NOS hi-flow bottle valve
remote nitrous bottle open/close solenoid with pressure gauge
secondary fuel cell and fuel pump for nitrous
(nitrous system is custom done with complete safety in mind)
holley 750 vacuum secondary with proform main body
Older Holley scorpion intake manifold
ported aluminum 58cc vette heads
heat wrapped hedman 1 5/8 headers (open up where y pipe would be)
comp cams magnum hyrdaulic flat tappet cam with 244int./244exh. at .050 inch lift
steel 1.6 roller tip rockers
march pulley kit
proform electric water pump
Intrax lowering spring
UMI subframe connectors
UMI LCA relocation brackets
summit racing drive shaft safety loop
Competition engineering 10 point roll cage
RCI 5-point harness
summit high back poly seat w/ leather cover
The interior is gutted except for the center console and the dash. The floor has been coated with a rubberizer. I have not installed the passenger seat that I purchased. If you want it installed I have no problem doing so. It is the same seat/cover combo as the drivers seat. I will install the matching 5-point harness if you want the seat intalled. The engine was completely disassembled and rebuilt a year and a half ago. It has seen only one strip pass and about 400 road miles from driving to the track and to work to show it off . All lights functional except for left turn signal (have not checked but believe to be just bulbs). Rear hatch motor is still fully operational as is the power steering and the power brake (disc all around)
Last edited by faulball67; 08-21-2007 at 03:15 PM.
#3
Member
Thread Starter
iTrader: (2)
Join Date: Aug 2005
Location: Columbus, GA
Posts: 315
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1986 IROC Z28
Engine: 350 carbed
Transmission: TH350
Axle/Gears: 3.43
Re: 86 street/strip camaro for sale
pictures
as you can see from the pics the pollen and sut down here has dirtied up the car, but it is just dust and wipes aways cleanly
as you can see from the pics the pollen and sut down here has dirtied up the car, but it is just dust and wipes aways cleanly
Last edited by faulball67; 07-26-2007 at 07:44 PM.
#4
Member
Thread Starter
iTrader: (2)
Join Date: Aug 2005
Location: Columbus, GA
Posts: 315
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1986 IROC Z28
Engine: 350 carbed
Transmission: TH350
Axle/Gears: 3.43
Re: 86 street/strip camaro for sale
price lowered
asking $5000 obo
asking $5000 obo
Last edited by faulball67; 07-26-2007 at 07:20 PM.
Thread
Thread Starter
Forum
Replies
Last Post
colton_carlson
Firebirds for Sale
7
03-08-2019 12:21 PM