91interceptorZ

iTrader: (3)

1991 Chevrolet Camaro B4C police special service package 1 of 592 made
Open to offers!







I am selling my Camaro interceptor, this car is pretty clean. odometer reads 207k, but entire drivetrain has only about 15k (not just motor, but all moving components). It is a drivers car so it does have minor scuff, and rock chips here and there, plus couple easily fixable door dings. However it is very clean, very shiny, and gets a LOT of attention. Only the best parts have been put into this car, nothing cheap goes on it. The car is usually just cruised around, but on occasion sees a road course or drag strip. Although I built it as a road course car, it will run into the mid to low 12's around 112mph. Where it shines is on the road course. The exterior and interior are kept clean and polished up, fluid changes every year in the transmission and rear diff and the engine get synthetic only. It has a very noticable exhaust note, with a very lopey cam, and sounds amazing. I have invested over $20000 into this car and love it!! I have owned this car for nine years. It is a hard to find police special service package and has the factory roll bar in it (rare). It does have the RPO code sheet to confirm it's a B4C car.
The A/C has been removed but can be re installed back into the car (parts not included).
Comes with power mirrors, locks, windows, power locking hatch, power drivers seat (8 way), power steering, automatic trans, 4 wheel disc brakes, airbag, cruise control, rear window defog, cd player with sub.
Below is some of the mods;

L98 5.7 litre V8 OE roller motor, Fully professionally rebuilt in 2010
Engine Mods: 494hp
High nickel block, matching numbers
Crank/rods balanced/sized by Precision crank
Ceramic coated pistons
Chrome Moly rings
Melling high volume oil pump
All Clevite bearings throughout
All felpro perma-dry gaskets
Procomp heads, 60 hours port work by Scott King of rocket heads
Port matched to intake and headers
2.02 1.60 manly swirl polished and undercut valves
1.6 comp stainless steel roller rockers
comp e-tec magnum pushrods with edelbrock guide plates
comp Xtreme fuel injection roller cam XFI280 .576/.570 230/236 @ .050
comp BeeHive matching valve springs to cam
GM roller lifters
comp double roller timing chain
engine oil cooler and engine oil filter cooler
moroso valve covers
TransAdapt underdriver pulley
Holley stealth ram intake 10 hours porting by Scott King
Holley stainless fuel rails
Holley adjustable fuel pressure regulator
BBK 1000cfm 58mm twin throttle body
Holley fuel pump 255lph
Holley Venom 30lb injectors
Custom built ram air intake tube with dual K&N filters
A/C pulley delete
Smog pump delete
Thermostat restrictor plate
Champion all aluminum triple core radiator with dual fans
High flow water pump
Flowtech headers ceramic coated and D-shape ported
3 1/2" ceramic coated mandrel bent exhaust through hooker aerochamber
MSD distributor, MSD wires, MSD 6A ignition box
PCMforLESS tuning with 7200rpm limiter
140 amp alternator
power steering pump cooler
new steering gearbox, ball joints (moog), power steering pump
700r4 transmission with kevlar clutch packs, corvette servo, tci valve body, high performance pump
RevMax 3600rpm stall convertor 9.5" with lockup
Adams custom balanced driveshaft aluminum with spicer u-joints
richmond 3.42 gears with eaton posi
moroso bearing press rear cover
Aux. transmission cooler
Energy suspension poly urethane bushings throughout
boxed rear trailing arms
KYB GR2 shocks
Boise spring works made custom lowering srpings
UMI performance rear trailing arm drop links
UMI performance weld in subframe connectors
BruteStop crossdrilled/slotted rotors with thermoquiet pads
factory 4 wheel disc car
New brake lines, GM
1LE sway bars with poly urethane bushings
UMI performance wonder bar brace

Factory 4-point roll bar
Teal Indiglo white face gauges
Gauge pod with AF ratio, vacuum and boost gauges
94 camaro Z28 seats
CD player with amp and sub
B4C and interceptor badging
Custom grill
black-out taillights
Diamond cut headlights with night glow mode
Custom black cherry 4 stage paint
hand sanded and polished 86 IROC wheels

Im open to offers

Steve Mack

iTrader: (5)

Do you have a dyno sheet That shows the 494 horse power numbers.

91interceptorZ

iTrader: (3)

Yes I do. Was dyno ran at local shop called performance solutions. Ill find them and post a pic.

vdavie

Rate the paint and body from 1-10.

Thanks,
Vince

91interceptorZ

iTrader: (3)

I would say the paint looks and finish wise itself is a 9. It was custom painted with three stage black cherry paint a few years back. there are a coulple minor blemishes...have tiny spider webbing on bumpers and few rock chips on hood. I would say overall it's a 7.5 .....all the flaws are not noticed about 15ft away. The paint looks deep black at night, and maroon purple in direct light....almost chameleon. The body is straight minus on small door ding on drivers front fender and a few minor ones in each door directly in middle.

91interceptorZ

iTrader: (3)

Im still looking for the sheet....it's here somewhere.