Ls1 4l60e drivetrain fitment
#1
Ls1 4l60e drivetrain fitment
I'm sure someone has answer this but I have a 89 Camaro that I have a stock 99 ls1/4l60e and aluminum ds to go with and I just need to know what do I need to buy to get the motor and trans and everything to set in and line up as factory as possible I know to run ac I have to k member but that's about it!
#2
Moderator
iTrader: (14)
Join Date: Mar 2000
Location: Littleton, CO USA
Posts: 43,169
Likes: 0
Received 35 Likes
on
34 Posts
Car: 82 Berlinetta/57 Bel Air
Engine: LS1/LQ4
Transmission: 4L60E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
If you want to use the factory AC compressor mounting position, you cannot use the adapter plates that use Gen I engine mounts. Meaning you need to get K-member swap mounts that use the 4th gen engine-side mounts.
You'll also need to get a swap tranny cross member. I like the Hawks for exhaust routing, but others work as well.
You'll also need to get a swap tranny cross member. I like the Hawks for exhaust routing, but others work as well.
Thread
Thread Starter
Forum
Replies
Last Post