dbrochard

iTrader: (3)

Do you have a front bumper for an 85 and up Camaro?

wwe442

iTrader: (2)

I should probably have a whole exhaust somewhere. I'm near Allentown kind of.

wwe442

iTrader: (2)

bump. Happy New Year!

kitt_me

iTrader: (3)

Looking for the Bumper mounting brackets



Pm me

iroczguy86

im looking for a factory exhaust with y pipe to fit my 86 iroc. its a 305 tpi. would u have any pieces to help me out/

tsev

Looking for 91-92 firebird GTA front marker indicator light harness in good condition?

wwe442

iTrader: (2)

PM sent

wwe442

iTrader: (2)

At the moment all I can think of is one on an 87 Sport Coupe v6. Most likely different

wwe442

iTrader: (2)

If it's 91-92 only most likely I wont have it at the moment

Gecz28

iTrader: (5)

any chance you have a red iroc or 91-2 z hood??

wwe442

iTrader: (2)

None at the moment in red, sorry

Black18Ice

Would you be willing to sell a section of the firewall for a manual trans? I need about a 12 inch section or so around the clutch master hole as mine is cracked and someone put extra holes around it.

Firebird Mess85

Any grey complete center consoles for an auto transmission?

wwe442

iTrader: (2)

I could probably work something out. PM me please

wwe442

iTrader: (2)

For a firebird?

89L98IROCZ

I need the nylon guides for the hatch motor and all the bolts for the plastic housing and to mount it to the trunk

wwe442

iTrader: (2)

I believe I have everything you need. Can you PM me with a zip for shipping? Also, are the nylon guides within the assembly? What year car is it for? Thanks!

wwe442

iTrader: (2)

bump

brentm76

Would you have the driver tail light for an 88 firebird formula? If so how much to 78624

wwe442

iTrader: (2)

PM sent

wwe442

iTrader: (2)

up

TX-SleeperC5

iTrader: (2)

I need a 1987 GTA front bumper and hood.... have them ??

Bounty Hunter

iTrader: (2)

Got any T-Top sets with the 3/4" pin?

wwe442

iTrader: (2)

I have both if you are still looking. Sorry for the delay in response, I havent been on the site in a while.

wwe442

iTrader: (2)

I believe I do have ttops with pins for sure, not sure if they would be 3/4 though. I didn't know they had different sized pins

speedingminivan

do you have the headlight lens buckets and retaining rings? need at least 1 pair.

please PM me!!

cHEVy hEAVy

iTrader: (1)

How much for the front leather seats? And are there any tears or cracks in them?

wwe442

iTrader: (2)

PM sent

wwe442

iTrader: (2)

They were vinyl and they're gone. I still have the rears, they are mint if I remember right. I also have a set of black leather rear seats. No fronts in leather or vinyl though

H-TownMinion

iTrader: (1)

Looking for a "fixed mast" (non-electric) antenna base/cable assembly. I only need what's below the fender to the radio for my '84 T/A.

-=Z28=-

iTrader: (3)

How much for the front skirt/bumper set up? Hatchback glass? where you located?

wwe442

iTrader: (2)

Can you send me a PM with your zip? And I'm assuming what you need is the bracket, base assembly that goes on top of the fender that the antenna screws into, and the cable? Thanks!

wwe442

iTrader: (2)

A front bumper cover with the ground effects would be $200. Glass depends on the year of the car. I'm near Allentown PA. Thanks!

H-TownMinion

iTrader: (1)

Ok, here's the deal. I have everything that originally came with the car, but the very end of the antenna cable that plugs into the radio is damaged and causes poor reception. I assumed this would require a full cable/antenna base assembly to repair, if I need more/less I'm all ears.

midge54

looking for lower shift boot and upper shift plate for 87 trans am t5

Irockthedrag

I need black rear carpet, a rust free ttop bar, side skirts without vents or door trim that matches the vented skirts, a black rear cargo cover(hinged style not the pull), a black lower center console, and a mint set of fenders.

I live relatively local and could probably pick up.

Irockthedrag

Forgot to specify for camaro

wwe442

iTrader: (2)

I don't have any sorry

wwe442

iTrader: (2)

Not sure if you are still looking, I haven't been on the site for a while so I apologize for the delay. I have the black carpet, side skirts, a console, and I have multiple sets of fenders

customblackbird

iTrader: (15)

I need a 85-90 TA tail light center section.

wwe442

iTrader: (2)

Message me with your zip and I'll get you a quote. Thanks

Reddeath210

iTrader: (1)

Would u happen to have a GTA rim non dimpled, need a front one.

wwe442

iTrader: (2)

I don't unfortunately, I actually need a rear rim myself for that 88 GTA I talked to you about. I can trade you a front for a rear but then I'd need a front lol

jacobvv

Do you have hood louvers that would fit a 1987 camaro iroc

loneroad

iTrader: (3)

looking for this,


http://www.thirdgenranch.com/catalog...178aa20cc938c2




also the plastic panel that attaches to the bottom of the front gfx and curvrs up towards the radiator.


please pm me if you have them, and ill give you my number for pics

89L98IROCZ

Do you have any hatch motor assemblies? I need all the bolts to put one together. PM me if you can help.

customblackbird

iTrader: (15)

I need the Driver side sill GFX brackets that bolt to the fender below the vent and rear quarter. (2bolt and 1 bolt) for a 85-90 TA? Got a pair? shipped to 07052 NJ?

backtothe80s

Looking for 1989 Trans AM GTA LH ground effect and air dam section. PM if available.

wwe442

iTrader: (2)

None sorry

wwe442

iTrader: (2)

I should have the air dam. Front or rear ground effect?