[FL] 1988 Trans Am
#1
Member
Thread Starter
Join Date: Jan 2010
Location: Seminole, FL
Posts: 239
Likes: 0
Received 0 Likes
on
0 Posts
Car: 88 trans am
Engine: 350sb
Transmission: t400
Axle/Gears: 7.5/2.73
1988 Trans Am
1988 Firebird Trans am 100,000 miles on chassis, under 1,000 on motor/transmission/driveshaft
TTops
Motor is a 4 bolt 350 small block fully rebuilt, bored .060 over
Patriot Performance Cylinder Heads
4 barrel edelbrock carburetor
edelbrock intake manifold
edelbrock viktor series manual fuel pump
hooker headers
GM replacement 4.060" forged pistons
Summit racing replacement rods
Eagle Crankshaft
.488 lift comp roller camshaft
Roller rocker arms and brand new push rods
T400 Transmission built for a top fuel car capable of handling 2000hp
Turbo Cheetah Shifter
Aluminum Radiator and 2 aftermarket 2750 cfm fans with a 190 thermostat
All new v-belt pulleys, power steering, water pump, alternator
PST ( clearwater company ) drive shaft
Motor was built by Godwin-Singer in St. Petersburg
The battery has died from the car sitting for too long, and the carbs need to be retuned
Body is in decent shape, no rust or big dents, car needs paint, is on 18" american racing rims with decent tires. Needs a little TLC but this car is a monster.
There is over $15,000 in work/parts in this car, unfortunately I do not have a place to keep it anymore or the time to complete it.
Figured I would post it here so maybe whoever buys my car will actually appreciate it, this was my first car, I don't want to see it rot or go to waste
Will post pictures later
looking to get 5000 obo
TTops
Motor is a 4 bolt 350 small block fully rebuilt, bored .060 over
Patriot Performance Cylinder Heads
4 barrel edelbrock carburetor
edelbrock intake manifold
edelbrock viktor series manual fuel pump
hooker headers
GM replacement 4.060" forged pistons
Summit racing replacement rods
Eagle Crankshaft
.488 lift comp roller camshaft
Roller rocker arms and brand new push rods
T400 Transmission built for a top fuel car capable of handling 2000hp
Turbo Cheetah Shifter
Aluminum Radiator and 2 aftermarket 2750 cfm fans with a 190 thermostat
All new v-belt pulleys, power steering, water pump, alternator
PST ( clearwater company ) drive shaft
Motor was built by Godwin-Singer in St. Petersburg
The battery has died from the car sitting for too long, and the carbs need to be retuned
Body is in decent shape, no rust or big dents, car needs paint, is on 18" american racing rims with decent tires. Needs a little TLC but this car is a monster.
There is over $15,000 in work/parts in this car, unfortunately I do not have a place to keep it anymore or the time to complete it.
Figured I would post it here so maybe whoever buys my car will actually appreciate it, this was my first car, I don't want to see it rot or go to waste
Will post pictures later
looking to get 5000 obo
Last edited by thebuffalo; 10-23-2014 at 10:23 AM.
Thread
Thread Starter
Forum
Replies
Last Post