LT1 VATS bypass
#1
Member
Thread Starter
iTrader: (1)
Join Date: Jun 2008
Location: Pittsburgh PA
Posts: 119
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1986 Camaro IROC-Z
Engine: 357 LTx
Transmission: T-56 6spd
Axle/Gears: GM 7.5 10 bolt with 4.10 richmonds
LT1 VATS bypass
Well first off I wasnt sure whether i should have put this ? in here or under the LT1 forum, but anywase I put it in both haha.... My ? deals with the VATS bypass on the LT1 ECU. It turns out when I sent out my compter to be burnt for the specifications of my engine they forgot to burn out the vats so now I'm stuck with a vehicle that will run for only 4 seconds and I was wondering if anyone would know which wires/pinouts on the connectors to the computer are the ones for the vats??? My plan was to locate those wires and splice resisters where neccessary. My other question was I heard of a piece you can purchase that plugs between the ECU connector and the ECU itself that is a VATS bypass module? has anyone else heard of this... I'm going to call summit/jegs and ask about it but I was just wondering if anyone knew of it or used it.
Thanks for the help
Thanks for the help
#2
Supreme Member
iTrader: (3)
Join Date: May 2004
Location: Kingsport Tenn
Posts: 1,036
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1992 camaro
Engine: LT1
Transmission: 4L60E
Axle/Gears: 3:73
Re: LT1 VATS bypass
Mabey this will help ?
http://shbox.com/1/vats_bypass.jpg
Or someone will chime in with a better way out.
http://shbox.com/1/vats_bypass.jpg
Or someone will chime in with a better way out.
#3
Junior Member
Join Date: Dec 2007
Location: defuniak springs florida
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1991 camaro rs
Engine: current tbi305 swapping to 94 lt1
Re: LT1 VATS bypass
ok i bought a vats bypass off of ebay and i=ts a three wire hook up for a 94 lt1 were would it go?
Thread
Thread Starter
Forum
Replies
Last Post