Machine Shop Time
#1
Senior Member
Thread Starter
Join Date: Jul 1999
Location: Chillicothe Ohio
Posts: 760
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 RS 355/ 89 IROC Convert
Engine: Hot Cam 355/TPI 305
Transmission: All 700r4's
Machine Shop Time
I am ready to have my short block done here is what I need.
.30 over
check rods & Crank
purchase & install bearings
deck the block and all the other little things that need done.
I also whant them to build the short block. I will provide the Pistons, rings,cam and timing gear, timing chain
How much can I expect this to cost, what is fair.
Thanks
Brian Felts
.30 over
check rods & Crank
purchase & install bearings
deck the block and all the other little things that need done.
I also whant them to build the short block. I will provide the Pistons, rings,cam and timing gear, timing chain
How much can I expect this to cost, what is fair.
Thanks
Brian Felts
#3
Senior Member
Join Date: Jul 1999
Location: Atco, NJ, USA
Posts: 726
Likes: 0
Received 1 Like
on
1 Post
Car: 1986 Z28
Engine: 355
Transmission: th400
I'd Say 600-700 depends on what needs to be replaced, and cut, if you have the gaskets, and all want them to degree the cam, oil pump, tanking the block, cam bearings, bored and honed, cut the crank, install the pistons on the rods, have them put it together, and check the oil pressure.
maybe a shade less. but that would be fair with having it done Right, and giving room for odd parts, and bolts.
------------------
It's always SOMETHING
maybe a shade less. but that would be fair with having it done Right, and giving room for odd parts, and bolts.
------------------
It's always SOMETHING
Thread
Thread Starter
Forum
Replies
Last Post
backtothe80s
Suspension and Chassis
33
09-05-2015 12:39 AM