PLANNING TO ENGINE SWAP A 2.8 TO A 3.1 TO A 3.4
#1
Senior Member
Thread Starter
Join Date: Jul 2010
Location: SAN DIEGO, CALIFORNIA
Posts: 350
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89RS-5.0/88IROC-Z-5.0/92-5.7 z28/v6
Engine: 5.0/5.7/2.8
Transmission: 5 spd in two stock auto in other tw
Axle/Gears: stock
PLANNING TO ENGINE SWAP A 2.8 TO A 3.1 TO A 3.4
SINCE these are all 60 degree blocks i am going to the junkyard to swap a 3.1 into a 2.8 just to for learning purposes and then to a 3.4 i will be using random camaros i find at the junkyard
PS THAT PLACE IS AWESOME(ecology/JY)
haha
how hard is it to drop the engine i know some1 was telling me i could drop suspension and k-member and drop engine out any tips or anything
COULD SOME 1 TELL ME THE EASIEST WAY OR THEIR OPINION ON HOW TO DROP THE ENGINE /TRANNY
if im pulling engine does the tranny come intact to the engine?
PS THAT PLACE IS AWESOME(ecology/JY)
haha
how hard is it to drop the engine i know some1 was telling me i could drop suspension and k-member and drop engine out any tips or anything
COULD SOME 1 TELL ME THE EASIEST WAY OR THEIR OPINION ON HOW TO DROP THE ENGINE /TRANNY
if im pulling engine does the tranny come intact to the engine?
Last edited by hasty88-and-89; 07-25-2010 at 11:58 PM.
Thread
Thread Starter
Forum
Replies
Last Post
theshackle
Tech / General Engine
4
03-05-2017 06:37 PM