Throttle body coolant bypass question
#1
Senior Member
Thread Starter
iTrader: (6)
Join Date: Jan 2009
Location: Texas
Posts: 517
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1991 Trans Am GTA
Engine: 350 tpi
Transmission: 700R4
Axle/Gears: 3.42
Throttle body coolant bypass question
What's up guys I had a quick question I was going to do the tb bypass on my caresume but since I don't have the heater valve do I just plug the port on the Intake?
#2
Supreme Member
iTrader: (3)
Re: Throttle body coolant bypass question
You don't plug the port on the intake manifold, that port is connected to the coolant send line that would normally route through the throttlebody which would be the line with the new hose clamp directly under the throttle positioning sensor in that picture you posted. you're just connecting the two lines with a fitting instead of connecting both lines to the throttle body.
#3
Senior Member
Thread Starter
iTrader: (6)
Join Date: Jan 2009
Location: Texas
Posts: 517
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1991 Trans Am GTA
Engine: 350 tpi
Transmission: 700R4
Axle/Gears: 3.42
Re: Throttle body coolant bypass question
Got it ok cause that line that goes into the tb comes from my radiator they cancelled the heater line and ran it from my radiator to the tb.
Thread
Thread Starter
Forum
Replies
Last Post
transamaster
Engine/Drivetrain/Suspension Wanted
3
04-30-2016 08:19 PM