Aftermarket Product ReviewProvide questions and answers about aftermarket parts for the Third Generation F-Body.
Welcome to ThirdGen.org!
Welcome to ThirdGen.org.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
o.k. today finished installing grant wheel #415 with installation kit #3196 . my car is a 91r/s with air bag , sun had curled edges , looked like crap . removed air bag ( see other posts on this ) , any way installation went pretty good . anyone with with an air bag ( 90-92 ) who does the same , keep yellow spacer/wire coil . cut off stuff from center out . use yellow center as spacer , don't forget spacer/sleeve that comes in kit . also had to trim about 1/8" off plastic housing on upper shaft housing . anyway thats the joys of hot rodding , make something work where its not supposed to . took it out for a drive , so very much better . love my new steering wheel . impressed by the quality of the product & feel . wish i had put them on some of my other 3rd gens . good luck .
kind of a bad pic, but you get the idea. its just one off the shelf of an O'Reilly's, but it looks a hell of a lot better than the one i used to have lol. and i never installed the horn with it. i just have a little button for a horn. installation was easy.
same wheel , i did hook up horn . pretty good installation , just posted extra info. for people with air bags . ( yes JamesC i did it myself ) oh well , time for another can of the golden nectar . skool .
I just put on my grant wheel as well. How does this horn hookup? On the column I have this round white plastic sleeve, and then I have another round white plastic sleeve that fits inside with a wire, spring and bell shaped connector on the end. on the back of the horn it has two slots for wires, one is the ground, but i only have the one wire. This is the last thing i need to finish before i can get it inspected.
I just put on my grant wheel as well. How does this horn hookup? On the column I have this round white plastic sleeve, and then I have another round white plastic sleeve that fits inside with a wire, spring and bell shaped connector on the end. on the back of the horn it has two slots for wires, one is the ground, but i only have the one wire. This is the last thing i need to finish before i can get it inspected.
you only need one wire for the horn button . the bottom/metal side of the horn button faces down . wire connects to top plastic side of horn button . shaft of column serves as ground . also review installation instructions on grant website . good luck .
![Ca[maro]88's Avatar](http://www.thirdgen.org/techboard/customavatars/avatar89811_8.gif){kind=avatar}
