Chopped HSR to fit under a C4 Vette hood - Page 2 - Third Generation F-Body Message Boards

LD85 · 05-01-2007, 07:55 PM

Quote:

Originally Posted by SilentBobZ28

Where's a good place to pick up a HSR at?

If you want t ouse 1206 Felpros, buy a new one, if not then get a used one

www.stealthram.com
----------

Quote:

Originally Posted by onfire

LD85,

Thats great work on that intake and that whole engine bay looks real clean. It seems like its a great balance of the three manifolds.

In terms of chip tuning, did you run into any troubles with those manifolds especially the miniram??

Rabi C.

The Super ram and Stealth were very very close to the same, I could not believe it.

The Miniram was a real pain, could not tune out the richness with 30# injectors, then went to SVO 24# injectors and it was better but not perfect.

M goal is to get a hi-rise hood and then add 2" to the top of the HSR intake thus lenghtening the runenrs to almost extactly half way between a SR and a Minram.

onfire · 05-01-2007, 09:45 PM

LD85,

Did you ever think of going to a solid roller cam? The miniram setup would have enjoyed that. I'm contemplating such a setup.

Rabi C.

LD85 · 05-03-2007, 08:29 PM

Quote:

Originally Posted by onfire

LD85,

Did you ever think of going to a solid roller cam? The miniram setup would have enjoyed that. I'm contemplating such a setup.

Rabi C.

Yes, but I decided to stick with Hyd-Roller, my buddy has a miniram with a similar Sold Roller grind cam and he traps at 120MPH @ 12.03

I currently trap at 116mph with a slipping clutch, so we'll see

JB97C5 · 05-03-2007, 09:07 PM

Quote:

Originally Posted by LD85

Thanks for the kind words,

I love being able to remove the plenum when I want!

With how many corvette owners there are trying to make HSR's work, you'd think holley would just fix the stupid too-tall design.

Nice work. Came out really good.

-- Joe

Yeah. I agree. Not much room under the hood of a C3 either...