Help identify these parts - Third Generation F-Body Message Boards

midnit · 09-10-2009, 01:16 PM

I have extra parts laying around, can you help me identify where they go and what they are for? Off an 86 camaro.

1. there are two of these, mirrors of each other

2. the other side of the above one

3. is this bent from factory?

This ad is not displayed to registered members.
Register your free account today and become a member on ThirdGen!

z28 TPI · 09-10-2009, 01:57 PM

The first 2 go to the headlight panel. The headlight panel might be "stuck" or bolted to the front fascia. One of those brackets is stamped with an L the other stamped with an R for left and right. The driver side being left. The brackets bolt to the top of thr radiator support. There is a triangle side of the bracket with a slot in it. That "triangle" has a flat side sits almost parallel to the fender. The bracket gets bolted to the center of the radiator support almost in line with the inside lines of the headlight buckets on the fascia. As for the last pic I can't help you I never seen a bracket like that. But it looks bent from the pic. I'm gonna take a stab and say it might look like a cruise control bracket but I could be wrong.

Thirdgen Ranch · 09-10-2009, 02:16 PM

It's a little hard to tell because of the angle that picture was taken at but I think the last item is the piece that attaches over the gas pedal.

84 1LE · 09-10-2009, 02:19 PM

Bottom pic is the hood latch support brace.It also bolts to the headlight bar.

midnit · 09-10-2009, 03:36 PM

Quote:

Originally Posted by Thirdgen Ranch

It's a little hard to tell because of the angle that picture was taken at but I think the last item is the piece that attaches over the gas pedal.

Ahh yes, that is correct!

midnit · 09-10-2009, 03:37 PM

Quote:

Originally Posted by z28 TPI

The first 2 go to the headlight panel. The headlight panel might be "stuck" or bolted to the front fascia. One of those brackets is stamped with an L the other stamped with an R for left and right. The driver side being left. The brackets bolt to the top of thr radiator support. There is a triangle side of the bracket with a slot in it. That "triangle" has a flat side sits almost parallel to the fender. The bracket gets bolted to the center of the radiator support almost in line with the inside lines of the headlight buckets on the fascia. As for the last pic I can't help you I never seen a bracket like that. But it looks bent from the pic. I'm gonna take a stab and say it might look like a cruise control bracket but I could be wrong.

Fantastic, thank you they are now where they belong