BodyGeneral body information and techniques for restoration, repairs, and modification.
Sponsored by ThirdGen Ranch
Welcome to ThirdGen.org!
Welcome to ThirdGen.org.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
Re: Factory emblems, did they use double side tape or glue
When I purchased these emblems they came with peal off backing and the adhesive was already on the back. I just had to press them on. Worked great. Two years now through many washes and rain and they are holding great. My advise is to find the distributor you want and double check with them on the install procedure. http://www.ecklerscamaro.com/product...dept%5Fid=1451
This one comes with a pins that pushes through holes on the nose and is held on with small nuts. Camaro Bowtie Front Emblem, IROC-Z & RS, 1986-1992
__________________ New Custom Rally Red paint , Custom Black racing stripes ,Open-air 14 by 3in. Spectre Element & Spectre X - Stream filter top /Goodmark Steel Cowl Hood /3in. American Thunder Flowmaster Cat Back / Magnaflow Cat / Corvette servo upgrade/ Extra manually switched Front Fan with 180 Thermostat / Derale Engine oil -Trans. combo Cooler ,28 spline Eaton Posi, 28 spline axles & gear ratio changes to 3.42 with L.P.W. Ultimate 10 Bolt cover.
Last edited by ronusmcmma; 02-08-2010 at 07:53 PM.
Reason: add info.
Re: Factory emblems, did they use double side tape or glue
On my car the "5.7 Tunded Port Injection" and "Z28" were on there with adhesive. And the side Z28 emblems were on there with double sided tape.
I took them all off to paint them and just used some double sided tape and theyre still holding up great after some brutal weather/washing.
Re: Factory emblems, did they use double side tape or glue
ah ok, yeah I got my car back from a paint shop and one of the emblems wasnt on there. They offered to put it on with double sided tape but I wasnt sure if this was right or not.
New Custom Rally Red paint , Custom Black racing stripes ,Open-air 14 by 3in. Spectre Element & Spectre X - Stream filter top /Goodmark Steel Cowl Hood /3in. American Thunder Flowmaster Cat Back / Magnaflow Cat / Corvette servo upgrade/ Extra manually switched Front Fan with 180 Thermostat / Derale Engine oil -Trans. combo Cooler ,28 spline Eaton Posi, 28 spline axles & gear ratio changes to 3.42 with L.P.W. Ultimate 10 Bolt cover. 
