BodyGeneral body information and techniques for restoration, repairs, and modification.
Sponsored by ThirdGen Ranch
Welcome to ThirdGen.org!
Welcome to ThirdGen.org.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
If you are talking about the sweep on the outside of the window you should be able to pull it up and off with out taking anything else off. It might fight a bit but it will come off.
All the ones Ive seen are held on with small 7mm bolts.To get access its easiest to pull the door panel off,then remove the 2 window felts so you can pull the glass away from the door a little bit.I removed a very nice one from a junkyard car and it was a real pita
82roc is correct . i replaced mine after new paint with 1a auto sweeps . was happy . don't expect all holes to line up perfect . not a1's fault , factory assy. was done on assy. line by humans . i used many small phillips head screws instead of 7mm heads . take your time , good luck .
I had to do a little bit of drilling for the last hole above the door handle and it worked out just fine. Doesn't look 100% in that area because it sits a little lower on the edge of the door because the of how the holes don't line up perfect but it looks much better than it did. Thanks.
82roc is correct . i replaced mine after new paint with 1a auto sweeps . was happy . don't expect all holes to line up perfect . not a1's fault , factory assy. was done on assy. line by humans . i used many small phillips head screws instead of 7mm heads . take your time , good luck . 
