92 Camaro Door Ground Effects Removal/Installation
#1
Junior Member
Thread Starter
Join Date: Sep 2009
Location: Atlanta, GA
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
Car: 92 Camaro RS
Engine: V8 305
Transmission: 5 speed
92 Camaro Door Ground Effects Removal/Installation
I have tried and tried and tried, and cracked, and broke, and damage many ground effects in different junk yard trying to remove them. It seems as if it is a very tedious task or require the right tool. Can somebody please give me some tips (even a tutorial video) on how to properly remove the ground effects. I know these steps below:
1. Remove door panel
2. Reach inside door panel and remove hex bolts, however; it is a challenge getting to all hex bolts!!!!
1. Remove door panel
2. Reach inside door panel and remove hex bolts, however; it is a challenge getting to all hex bolts!!!!
Last edited by kanine704; 03-27-2014 at 11:27 AM.
#2
Supreme Member
iTrader: (3)
Join Date: Jun 2007
Location: Pennsylvania
Posts: 2,359
Likes: 0
Received 5 Likes
on
5 Posts
Car: 1992 Camaro RS
Engine: Rebuilt 350 going in after paint
Transmission: WCT5, 7k & counting behind the 350
Axle/Gears: 4thgen disc rear w/ 3.73 Posi
Re: 92 Camaro Door Ground Effects Removal/Installation
The trick is turn the wrench SLOWLY. The studs are made of the same urethane as the GFX, so they do break easily. I use a ratcheting 10mm straight wrench and 2 fingers on the side to turn it gently. Also, make sure you aren't pushing towards the outer door panel(down on the stud). The nuts are designed to cut their own threads and they can easily cut the stud off if they keep spinning in one spot too long.
#4
Member
iTrader: (1)
Join Date: Oct 2004
Location: Munford, TN
Posts: 200
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 z
Engine: Chevy 383
Transmission: 700R4
Axle/Gears: 9 bolt 3.73
Re: 92 Camaro Door Ground Effects Removal/Installation
I have tried and tried and tried, and cracked, and broke, and damage many ground effects in different junk yard trying to remove them. It seems as if it is a very tedious task or require the right tool. Can somebody please give me some tips (even a tutorial video) on how to properly remove the ground effects. I know these steps below:
1. Remove door panel
2. Reach inside door panel and remove hex bolts, however; it is a challenge getting to all hex bolts!!!!
1. Remove door panel
2. Reach inside door panel and remove hex bolts, however; it is a challenge getting to all hex bolts!!!!
Thread
Thread Starter
Forum
Replies
Last Post
92firebirdchris
Exterior Parts for Sale
0
08-14-2015 11:56 AM
IROCZDAVE (88-L98)
Interior Parts for Sale
0
08-06-2015 03:51 PM