Replaced Rotors/Pads/Calipers now front brake stay locked.HELP

[1lecamaro]

Alright I put all new parts on the front after I cracked two rotors that were old and wore out. I bled the system with a professional power bleeder 3 times to make sure now that was not the problem. So at that point I took it out and the brakes randomly lock left or right every time I barely put the brakes on. I got fed up after taking the whole thing apart a couple times I put it in storage. Now I brought it back out and they remaine locked, so I had a hard time getting it up the driveway without spinning the back tires. I don't know what to do other than replace the calipers that are already new, maybe I got a bad set that doesn't travel in the bore correctly. FYI 1989 350 Iroc stock style brakes iron calipes, drilled/slotted rotors/ Bendix heavy duty pads

[//<86TA>\\]

a good possibility is that the rubber flex lines have gone bad and are collapsing causing the calipers to lock, its quite common

[k10mracing]

sounds like the rubber brake lines are collapsed letting you aply the brakes but they will not release the fluid to let the brakes off .

[1lecamaro]

thats what I was thinking. I am checking into it.

[1lecamaro]

thats what I was thinking. I am checking into it.

[Justbrilliant5]

same problem-front brakes didn't release.. replaced brake lines, and it stops like new. The clips are a little pesky. Lucky I had a very large pair of vice grips.