Its time for me to sell my car. College is taking up too much of my time, and I dont have time for a job to find this project, nor time to work on the project. This car was used for abotu 2 years as a daily driver by me. Very powerful and reliable 305. Its been nothing but fun since ive had it.
Borg and Warner Posi Rear End 3.42 gears w/stock Proportional Valve
New Rear End Seal and Redline Synthetic Gear Oil with Posi Additive
Big rear Sway Bar
Energy Suspension Rear Sway Bar Bushings
Energy Suspension Rear Sway Bar Front End Links
Energy Suspension Rear Sway Bar Rear End Links
Energy Suspension Transmission mount
Corvette Shift Servo
Accell 8.8mm Wires
Accell header Plugs
Edelbrock TES Headers
Edelbrock Performer Intake Manifold
Holley Open Air Element with K&N Air Filter
Removed Emissions
Flowmaster Muffler
HyperTech ECM Chip
Hijacker Air Adjust Shocks
Shaved RS Emblems from GFX
New Parts/mantinence installed:
Full new brake job
- New Calipers (1k on rear about 4k on front)
- New Rotors (1k on rear and front)
- New Front Lines (4k miles)
- New Master Cylender (about 4k miles)
- New Pads All around (abotu 1k miles on all)
Distributer Cap and Rotor
PCV Valve
Breather Element
Oil Change (1k miles)
Starter replaced 3k miles
Alernator (approx 3k miles)
Water Pump (pprox 5k miles)
Coil Pack with about 3k miles
160deg thermo (unknow milage becuase I run 195 in winter and 160 in summer, been using the two for about 10k miles total)
other things:
Greased Chassis about 1k miles ago
upgraded Headlight Wires
Glass Housings and h4 Headlight Beams
Custum gauge inlays
Targa Hatch
Tires with about 10k miles
Sub Box for 12" subs, fits in the t-top well in the back
Kenwood Replacments in the Sail Panels
Pioneers in the Dash
Newer Un Cracked Dash Pad
Distributer with 10k miles
Ignition module with 3k miles
Faze 5" Tachometer
Rubberized rear Hatch Area
Grant GT Steering Wheel
4th Gen Front Seats
Im sure there is more in there somewhere that ive jsut forgotten about
Asking 3000, motivated to sell My email address is
solarofthesix@hotmail.com, car is located in Irmo/Columbia, South Carolina. It can be driven wherever you want it to be taken. If Buyer Arranges shipping I will do whatever is needed to assist on this end.
parts included:
416 Casting heads
Le Bra
Many interior panels and parts including a 4th gen center console
lt1 Cam
Chrome Plug Wire Looms
Blue, red, and Black rubber plug wire retainers
Wing Nut style valve cover bolts for perimiter style
Full Gasket Set
Chrome timing Tab
z28 Style Fog Light Grill
Fog Lights
Oil Filter
Stock Hatch
Black Bucket seats for rear
MANY MISC PARTS that i have collected and will no longer need as I am moving to a 4th gen...
this will be a nice project car, for someone as it is runing strong and reliable...and is in decent condition and includes many new parts.
