[MI] 88 IROC project or parts
#1
Junior Member
Thread Starter
Join Date: Dec 2011
Posts: 67
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1988 IROC-Z
88 IROC project or parts
Well I'm giving up on my 1988 IROC. I can text the few pics I have but I need to take more. I will try to be descriptive as possible.
The Body: in gray primer. Few small dings, no bondo. Front fenders removed. Driver side is junk. No hood. Ground effects removed and in fair condition. Windshield is gone. Passenger window removed but in good condition. Large patch in drivers side floor. Hole cut in tunnel for tranny swap. Pedals and master cylinder installed. Inside coated in por15 silver. Engine bay in satin black. Clear title.
Car has 2:73 disc posi rear
Parts: new ez harness 21 circuit haven't stripped wire yet. World class t5, Hurst shifter, gently used Kevlar clutch. 88 trans am ecm and harness. A/c delete box. Fuel rail, plenum, runners, lots of interior pieces.
I got around $2400 into it. I'd like to get $1800 or best. Will part.
The Body: in gray primer. Few small dings, no bondo. Front fenders removed. Driver side is junk. No hood. Ground effects removed and in fair condition. Windshield is gone. Passenger window removed but in good condition. Large patch in drivers side floor. Hole cut in tunnel for tranny swap. Pedals and master cylinder installed. Inside coated in por15 silver. Engine bay in satin black. Clear title.
Car has 2:73 disc posi rear
Parts: new ez harness 21 circuit haven't stripped wire yet. World class t5, Hurst shifter, gently used Kevlar clutch. 88 trans am ecm and harness. A/c delete box. Fuel rail, plenum, runners, lots of interior pieces.
I got around $2400 into it. I'd like to get $1800 or best. Will part.
Thread
Thread Starter
Forum
Replies
Last Post
mustangman65_79
Body
3
08-11-2015 03:17 PM