Viola4lfe

I am looking to sell my 84 camaro. I have owned it for 2 years and I am looking for a more nimble car to do some hpde events as well as make the switch to fuel injection.
The car has t-tops (little-no leakage) and is a factory 5 speed.

-350 engine(1971 block 010) bored .030 over with 10:1 compression ratio
-GM cast iron heads pocket ported with 1.94/1.5 valves with full roller rockers
-Edelbrock air gap performer with Holley 600cfm 4 barrel
-214/224 degree duration at .050, .442/.465in lift cam.
-The complete rear was redone(5000mi) including brakes. It has an Eaton posi unit with 3.42 gears(Richmond)
Paint and body is in ok. condition. I had it repainted when I bought the car and normal front bumper cracking and chipping has begun.
Pulls hard and runs really well. I have done a few AutoX events and it performed very well which is why I'm thinking of moving to a Miata.

-$3800/o.b.o
Feel free to PM me for contact information if you would like to speak with me about the car otherwise drop a reply

rkg8554

iTrader: (10)

How are the floor pans and rear quarters as far as rust ? Any rust issues any where ? Any picks of under hood ? How is the radiater core support, the lower one ?

Viola4lfe

Everything is really solid. Like I said I've done a couple of autox events with it and it performed very well. PM with your contact information and I will send you pics of under the hood as well as answer any other questions you may have including giving you the 360 walk around