DFI and ECMDiscuss all aspects of DFI (Digital Fuel Injection), ECMs (Electronic Control Module), scanners, and diagnostic equipment. Fine tune your Third Gen computer system for top performance.
Welcome to ThirdGen.org!
Welcome to ThirdGen.org.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
I have two camaros an 86 z-28 and an 85 camaro sc. The wiring in the z is shot so i was going to put the harness from the sc in it. I though i read somewhere that there was basically no difference in the fuel injected harness. So i was wondering if i could burn a new chip for a v8 and put it in the origanal sc ecm and get all the v8 specific sensors would it work? I also have a 7749 ecm that i could rewire to and put in. I'm very good at wiring so modifying any of the harnesses is no problem. But if it happens to be out of my skill range i'm good friends with the owner of kwick wire that does street rod harnesses so i could have him modify it.
This ad is not displayed to registered members. Register your free account today and become a member on ThirdGen!
Sponsored Links
Registered users do not see this ad. Click here to register for free!
