DFI and ECMDiscuss all aspects of DFI (Digital Fuel Injection), ECMs (Electronic Control Module), scanners, and diagnostic equipment. Fine tune your Third Gen computer system for top performance.
Welcome to ThirdGen.org!
Welcome to ThirdGen.org.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
Around 6 monthes ago, i made a winaldl cable and downloaded winaldl on my laptop. It worked fine w/o a hitch. Now, the cable is missing and i made a new one. When i hook it up without the R3 and R4 resistor in place, i get only a couple lines of raw data reading. (car is an 86 lb9.) With the R3 resistor in place, i get all the sensor data but nothing more than that. All along, with either setup, i get the little red flashing 6 in the top of the winaldl box. The cable seems to be built to the same schematics as the one diagram that everyone has seen. Whats the deal? Anybody else have the problem of the little box at the top of the screen flashing red and reading 6? When i put in the R3 resistor, it turns green and reads 20 but still doesnt provide any data except the error codes and sensor readings.
This ad is not displayed to registered members. Register your free account today and become a member on ThirdGen!
Sponsored Links
Registered users do not see this ad. Click here to register for free!
