i have a hypertech stage ii for now..................i stumbled on this eBay Motors: RACING CHIP Trans Am Firebird 88 89 90 91 92 93 94 95 (item 8069836163 end time Jun-02-06 23:23:06 PDT) was looking for feedback

mmmmmmmmmm, ebay , what am i thinking, im going to have superchips make me a new chip and throw this hypertech thermomaster in the trash, if they still make chips for 91s

To be honest, you are better off learning how to do it yourself. The equipment costs are less then the cost of an over the counter chip. And, you can make whatever changes you would like.

RBob.

is there a step by step including items id need? i build my own comps so i could probably handle it

http://www.thirdgen.org/promintro


am in the right place?

Yes, a decent start. Just a headsup, that article is probably a little dated. There are less expensive and better tools available today.

RBob.

and id find these where? ive decided, b4 i do the cam and heads, im going to master the chip burning first on the motor now..........................i need to read the hypertech i take it? and go from there? or start with the stock chip?

well, ive been reading for about 3 hours now, i understand easily what i need and how to go about it, and that it will take some time and error to get it just right, but i still dont understand how to go about making changes, i guess i would need to understand what each setting is like,

main spark table...........................what is it

wot afr vs rpm

crank afr vs coolant

where can i find explanations of what each setting is? i think if i knew what each setting did id understand how to make changes to it much easier

bueller?

anyone?