LT1, with Megasquirt and EDIS/Distributorless ignition -toothed wheel question - Third Generation F-Body Message Boards

Thirim · 06-03-2008, 10:44 AM

I already have my LT1 in my '89 TA. works great with tunercat.
I want a little more control and visibility as to what the motor is doing. Megasquirt was the cheapest and in my case the best choice.

Trying to figure out if there is a 36-1 toothed wheel that someone has found to fit the crank pulley without too much modification. I want to run EDIS (already have the parts) so that i can go distributorless. I'm figuring on using LS1 coils.
Can anyone point me in teh right direction? I found a great article on it from a guy who put an LT1 into an S10, but the article fell short of the actual wheel used.

Thanks.

Ward · 06-11-2008, 04:22 AM

You should be able to use a ford ring. This one on ebay has measurements provided. If you can weld it to the back of the crank pulley or balancer, it should be fairly easy to make a bracket for the pickup, using one of the accessory bolts.

http://cgi.ebay.com/ebaymotors/EDIS-...m110261073302&