Firechicken86

iTrader: (1)

I just got a new aftermarket chip to bypass VATS and went to go take out the stock one but it doesn't come out! I've tried prying underneath the chip but it's pulling out the terminals so I don't want to damage anything. Is there a proper way to remove this? thanks

Six_Shooter

iTrader: (2)

The stop EPROM is soldered in.

The best way is to get an adapter that will allow the LHM and Knock filter of the original MEMCAL to be retained and allow the new E/EPROM to be placed in such a way that the ECM reads it.

Moates.net is one such place that sells the adapter. Look at the G1.

Tuned Performance

iTrader: (92)

Its easy to unsolder the stock eprom nd solder in a d2 dip. You just about destroyed that memcal.

Firechicken86

iTrader: (1)

I know, I realized too late that it can be easily unsoldered. Does it look too damaged to function from the pic? I'm not sure how sensitive these things are and the bypass chip doesn't seem to be doing a whole lot. This is the issue I'm stuck with and I'm trying to determine if it's VATS related
https://www.thirdgen.org/forums/tech...ml#post5553946

Tuned Performance

iTrader: (92)

The no legs are broken on the eprom so it should still function properly, I tried to load the video and nothing happens.

Firechicken86

iTrader: (1)

Okay I'll try an upload it to another host site. Should be up in a few minutes

Firechicken86

iTrader: (1)

New links are up on original thread

Tuned Performance

iTrader: (92)

I will install a dip and reprogram for this months vats disable special if thats of any interest.

https://www.thirdgen.org/forums/spon...ial-month.html