Craig, any update? I'd love to upgrade my Prominator to a USB setup, and I quoted your post above over on corvetteforum in response to a question I got about my TPI installation. I think you'll have a number of folks interested.

Apologies for the delay on this, I've been off on so many tangents it's not funny.

Here's a teaser if it helps. I can't say exactly when it'll be ready, I've got probably about 10 more traces to lay and then the FW to work out.



At its largest measurement, it is 1.4" x 1.6".
A 28-pin chip, by comparison, is 0.6" x 1.5".

Mini USB cable comes off right next to pin 28.

Hmm, well, I'm still excited Mr. Moates, very excite, can't wait, but have to... soo, still patiently waiting in excitement. Yes! I look forward to being able to order from you and start out on the tuning road. Thank you for dedicating time to this, we all appreciate it greatly!

I would like to go on record as also being interested in the PromulGator. When these are ready please let us know. Perhaps it will be ready in time for Christmas!

That's a lot of pressure. 2010?

But I've been such a good boy this year!

I'm ready for one of these too. I'm just finishing up a 383 (385 actually) swap with a mild cam upgrade, rockers, pushrods, lifters and some older GMPP iron heads that I ran through, but with the stock chip and TPI. As expected it needs to be feathered at start up and stumbles at idle. It throws engine code "44" so I'll be testing/swapping the 02 sensor next -- it's definitely not running lean though and smells rich with its fresh new appetite for pump gas. It also runs way hotter. I'm pretty sure that I can DIY tweak my problems away with a promgulator and its supporting cast so please post when you are taking orders (even if I have to wait :-).

I'm on it. Sorry for the delay, I've almost got my plate cleared and ready to jump back to it. Soon....

Heya Craig Any update on the status of availability?

No, but get with me offline via email and I'll hook you up good.

Hello Craig, I got you email about my Prominator repair. Thanks for the other options, I'm def considering them... I might be able to push back my dyno appt. for later in the month. Any idea when u could have the Prominator repaired it I wanted to stick with it??

Any updates on the promulgator im getting the car back on the road with a new cam and using old chips and a uv eraser isnt cutting it, i was looking at the ostrich, the ebl is a little out of my price range, this would fit the bill perfect, thanks.

any updates on the PromulGator craig?