DIY PROMDo It Yourself PROM chip burning help. No PROM begging. No PROMs for sale. No commercial exchange. Not a referral service.
Welcome to ThirdGen.org!
Welcome to ThirdGen.org.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
I need some help on a new set up . For starters i lost a valve spring on a 10,000 Km motor an well we all no what happened from their . So i'am starting this project all over again , this is what i have to work with .
355 cu in ( roller block )
four bolt mains
First Tpi set up
LT1 injectors flow matched 26lb @ 43.5 psi
Vortec heads port matched , will be machined for higher lift
PCM modded for PFI
Speed Density
Comp cam # 08-502-8 ( did not like )
The heads i was told are good for 400 HP max and same for the injectors ?
The Comp cam i would like to go with this time is # 08-466-8 and use the 1.6 :1 rockers . I would appreciate some suggestions or opinions before i start tearing things apart , this way it gives me something to think about in the process . One thing i should mention is this motor is going in a 4x4 and torque i think is the way to go . Almost for got one other thing to think about is emissions , i don't need EGR or CCP but need the Cat . As of last year they did not care what i had as long as it passed the sniffer .
Thanks
__________________ Dan - ASE certified-A1, A4, A5, A8 This is for all things four wheeled and fast...
95 S10 ecsb-350ci, Ported 906 vortec's, L31 intake, 9.5:1, Crane(.484/.512 216/228 112LSA), Hooker Super comps, 2.5" ORY, E-cutout, 40 series flow, 4L60E, 8.8 f*rd posi w/ 3.73's, 7427 PCM, MPFI mode, $OD, WB02. - Daily Driven!
Go here http://www.firstfuelinjection.com/ very nice set up talk to Ken . Look at the projects an you'll see my set up , their very first FIRST for Vortec's .
They all look nice, what one is yours? Do they manufacture a vortec specific TPI baseplate or do they just wobble out the holes for the different angle and not use the center two?
__________________ Dan - ASE certified-A1, A4, A5, A8 This is for all things four wheeled and fast...
95 S10 ecsb-350ci, Ported 906 vortec's, L31 intake, 9.5:1, Crane(.484/.512 216/228 112LSA), Hooker Super comps, 2.5" ORY, E-cutout, 40 series flow, 4L60E, 8.8 f*rd posi w/ 3.73's, 7427 PCM, MPFI mode, $OD, WB02. - Daily Driven!
