I noticed the O2 counts jumping all over the place. Bad O2 sensor? and the BLM's didn't look right either. First time doing this so if you could give me some pointers i would greatly appreciate it thanks.

Any comments?

There is not much to see from this log. It looks like you just let it warm up and thats about it. Take it for a spin and get a better data log. The O2 bouncing around is pretty normal. Its supposed to go back and forth between lean and rich. Your BLMs are a little off. This site has all the info you need to tune your ECM. Just do some searches, read the stickies, and have fun.

Well in michigan there is alot of salt and snow on the roads so she'll have to stay in the garage and just idle for now. And I did read the articles and stickies, I'm just looking for a little help from anyone. After all that is what a forum is for. I plan to buy the burning equipment this summer and start tweekin stuff then. thanks for the input.

bump...