zero out adder tables
#1
Supreme Member
Thread Starter
iTrader: (-3)
Join Date: Dec 2012
Posts: 1,184
Likes: 0
Received 1 Like
on
1 Post
Car: 1991 firebird
Engine: TBI 305 (built)
Transmission: T5
Axle/Gears: 4.10
zero out adder tables
I need to know exactly how to zero out ALL SA adder tables .. I only want to use the main and extended SA tables for my timing .. thanks in advance ...
#2
Moderator
iTrader: (1)
Join Date: Mar 2002
Location: Chasing Electrons
Posts: 18,400
Likes: 0
Received 215 Likes
on
201 Posts
Car: check
Engine: check
Transmission: check
Re: zero out adder tables
Not all of the SA tables are adders. Many can both add or/and subtract. But to run on only the two main SA tables...
EBL Flash, here is what to do:
That should cover it. May have missed something, just double check it.
RBob.
EBL Flash, here is what to do:
Code:
Zero out: SA - Idle State SA SA - IAT/CTS Comp Bias SA SA - Coolant Comp Bias SA SA - ALDL Mode Added SA - PE Attack Rate/Fifth Sec SA - Coolant Comp Spark Advance SA - IAT/CTS Compensation SA - PE Adder vs Gear/RPM SA - TCC Locked Retard SA - Idle High Compensation SA - Idle Low Compensation SA - HiWy vs MAP SA - Launch Mode SA - Startup Choke SA - Attack Rate Un-check this option flag: Option Word 2 - Bit 1 - IdlSa
RBob.
#4
Moderator
iTrader: (1)
Join Date: Mar 2002
Location: Chasing Electrons
Posts: 18,400
Likes: 0
Received 215 Likes
on
201 Posts
Car: check
Engine: check
Transmission: check
Re: zero out adder tables
Try it and see? I was wondering why you would want to do this. I did it once but only to test the latency of various ICMs. Although I did start the engine on a normal calibration then switched t the one with the set values.
RBob.
RBob.
#5
Supreme Member
Re: zero out adder tables
My thoughts as well. Some adder tables address specific situations that are transitional.
#6
Junior Member
iTrader: (1)
Join Date: Aug 2009
Posts: 62
Likes: 0
Received 0 Likes
on
0 Posts
Car: 92 camaro
Engine: 406
Transmission: 700r4
Axle/Gears: 3.73
Re: zero out adder tables
Can you send me a picture of how you zeroed out tables on you pe table for example I just learning what these terms are
Thread
Thread Starter
Forum
Replies
Last Post
86CamaroDan
Engine/Drivetrain/Suspension Parts for Sale
2
09-29-2015 10:08 PM
sailtexas186548
Problems / Help / Suggestions / Comments
2
08-24-2015 10:11 PM