Anyone have a chip adapter fail on them?
04-07-2014, 06:27 PM
#1
Supreme Member
Thread Starter
Anyone have a chip adapter fail on them?
I've had this Hypertech one for a little over 10 years now. It failed the other day...
I have another one such that when I swap it in, everything works, so I know it's this particular adapter.
Just curious if anyone else has experienced a failure like this.
I have another one such that when I swap it in, everything works, so I know it's this particular adapter.
Just curious if anyone else has experienced a failure like this.
04-08-2014, 10:43 AM
#2
Re: Anyone have a chip adapter fail on them?
Yes I used an adapter(Moates) that fit into the socket and used a spring to hold prom rather than snap fit(zero force insertion?). Over railroad tracks of a good bump it would go to limp and my car would not run right as the calpack was 6 cyl and I am 8. I ended up not using it as I needed to drive over tracks daily!
Thread
Thread Starter
Forum
Replies
Last Post