How to get AE vs RPM on 7730
#1
Supreme Member
Thread Starter
How to get AE vs RPM on 7730
So I found a trick...
Enable the setting "Reset Integrator when AE in progress"
Then, play around with the VE at high MAP
It's working out big time for me. Instead of global delta MAP or delta TPS changes ( sometimes resulting in areas where i dont want it( I can target AE directly to the RPM range I want.
I think what's happening is the ECM is momentarily disabling the auto-adjust when there's a change in throttle position, so while it's "looking the other way", I sneak in some extra fuel via the VE table without the ECM trying to trim it back out. By the time the AE event is over, it's too late for the ECM to do anything about it.
Enable the setting "Reset Integrator when AE in progress"
Then, play around with the VE at high MAP
It's working out big time for me. Instead of global delta MAP or delta TPS changes ( sometimes resulting in areas where i dont want it( I can target AE directly to the RPM range I want.
I think what's happening is the ECM is momentarily disabling the auto-adjust when there's a change in throttle position, so while it's "looking the other way", I sneak in some extra fuel via the VE table without the ECM trying to trim it back out. By the time the AE event is over, it's too late for the ECM to do anything about it.
Last edited by ULTM8Z; 06-28-2014 at 11:12 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Damon
Tech / General Engine
8
09-26-2015 04:29 PM