DIY PROMDo It Yourself PROM chip burning help. No PROM begging. No PROMs for sale. No commercial exchange. Not a referral service.
Welcome to ThirdGen.org!
Welcome to ThirdGen.org.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
I have a akm cable and moates software and can't get it too hook up. Tried two different computers and two different 165's, used hyperterminal on both computers and the cable checked out, started up in dos on both, used some software to check the interface and that checked out okay. I've played with the grounds and everything else and no luck. Its for an 86. I need some ideas, I've been messing with it for two weeks and no luck.
mine takes about 1/2 second then i get takeninto the program. are you 100% sure that everything is hooked up right? we made a cable and it checked out on hyperterminal but wouldnt link to the car. you do have the 10k resistor in there right?
__________________ Brandon ....
"ScreaminDeamin 360"
1989 IROC 350 60 over, TRW forged 9.83:1 pistons,Hooker Comp headers, crane cam 222/234 .497/.526, crane 1.6 RR's, ported plenum, home made ram air, 24lb SVO injectors, crane AFPR, all going through 3 inch mandrel pipe and a flowmaster. T-56, Pro 5.0 Shifter, McLeod clutch, LT4 PP, Jamex Springs, MAC Sfc's
Newest Pictures http://screamindeamin.cz28.com/newimages http://ScreaminDeamin.cz28.com
It was my fault. In the instructions it said use the female connector on the aldl side. Well I used the male connector and that screwed up my pins to solder to. Got it working and it works great. But now I have to get a new harddrive for my laptop since it broke a couple of days ago.
