hi im tryin to get my turns signles to work properly. like when i put the hazards on all of them blink excupt for the back driver side. and when i put just the turn sigle on, on that side it just stays lit up and no blinky and still the back driverside turn signal wont light up. can any one give me any help i need to get this done for inspection. thanx

you have a few bulbs out, atleast thats what was wrong with mine.

------------------
neko
'87 trans am
car in the making

Yup, you probably have a bulb or two out. They may have bad elements or just dirty connections. Get to the bulb(s) that aren't lighting and twist them back and forth to clean up the connections a little.

The reason they don't flash when the blinker is used, but do with the hazards is because the flasher works off of current. With a bulb or 2 out there is not enough current to operate the flasher, but there is with the other bulbs operating with the hazards.

Search the archives, I've covered this topic in more depth before.

Don't forget to check the side marker bulbs too. Any bulb burned out in the set will cause your condition.

------------------
87 TA, 305 TPI, Custom CAI, K&N, ACCEL 8mm wires,ACCEL Super-coil, ACCEL Plugs, JET TPI Airfoil, Cherry Bomb Muffler, 160* thermostat
The Phoenix Project..click to see my project car
Trans Am stuff and GIRLS, GIRLS, GIRLS!!!!!