fuginasso532

this may sound extremely stupid but...oh well.. here it goes. my rear right signal light is out. how do you take apart the fixture to replace the bulb. i tried to inspect it but it looks like the fixture is one bonded piece of plastic glued together. i didnt see any screws really. just a couple for the license plate lights. but i dont know how to access the corner lights. please help me on this issue. i may be out of place asking this question but i dunno where else to go. any help would be appreciated.

MdFormula350

open the hatch, pull the rear interior plastic piece that lines the whole rear area of the trunk well out. after that u will see most if not all of the plastic wings nuts to take the tail lights out.

Trickster

Okay fuginasso532,

here you go in several easy steps.

1. open hatch
2. remove two fasteners at ends of trim panel.
3. remove two screws near hatch catch.
4. remove trim panel
5. remove five wing nuts holding taillamp lens.
6. remove taillamp lens.
7. remove bulb from socket.
8. replace bulb in socket
9. replace taillamp lens
10. replace wing nuts
11. adjust taillamp lens for proper appearance before tightening the wing nuts.
12. install trim panel
13. install screws dear hatch catch.
14 install fasteners at ends of trim panel.
15. close hatch.

Done!!!!!!!!

Brets_TA

iTrader: (1)

I figured out there is 10 butterfly screws, I kept hearing 6 there is 3 on both ends of the car and 4 in the middle, confused me. I assume I only need to unscrew the 6 end nuts and leave the middle 4 alone. Solved

Beau27

Are the bulbs really supposed to come out? Mine don't seem to want to twist or come straight out. I think they have been in there for so long that they have fused together or something. What is the exact method of removing these? Twist and pull, or just pull? Thanks.

The same goes for the front turn signal bulbs. I pulled on it and the glass came apart from the metal base.

afremont

You push the bulb in slightly and then turn it about 90 degrees like you are unscrewing it. It then pulls out of the socket. You should be able to get the old base out by grabbing the brass with a pair of needle nose pliers and following my directions.

EDIT: Be careful when putting a new bulb in. On the double filament bulbs, there are two locking pins that stick out of the side of the base. One sits deeper in the socket than the other. If you put it in backwards, it might go on in but the bulbs will burn the wrong brightness.

Beau27

Thank you. I was able to get them out exactly as you said.
I am doing an LED conversion.

BK2FUTR

@beau27 how did your taillight conversion turn out? Im thinking of doing it myself as well!