turn signal flasher
#1
Senior Member
Thread Starter
Join Date: Oct 2001
Location: Lancaster, CA.
Posts: 642
Likes: 0
Received 0 Likes
on
0 Posts
Car: '92 Camaro RS
Engine: 355 TPI
Transmission: Tremec T-56
Axle/Gears: 10 bolt/3.42
turn signal flasher
I have a '92 RS and I think I need to change the turn signal flasher, when the lights are off and I turn on my blinkers they dont blink, they just stay on. When the lights are on and I turn on my blinkers, the fronts dont do anything and the backs just stay on. Hazards work fine. What does the flasher look like in a '92 Camaro ad where can I find it?
#2
Supreme Member
iTrader: (2)
Join Date: Dec 2005
Location: Beaufort South Carolina
Posts: 1,739
Likes: 0
Received 4 Likes
on
4 Posts
Car: 1983 Camaro Z/28
Engine: LU5 305 CFI
Transmission: 700R4
Axle/Gears: J65/G80/G92-3.23
Are both the left and right turn signals doing this or just one side?The reason I ask is if just one side it's usually a bad bulb.The turn signal flasher,if your '92 is the same as my '83 is located in a convienence center to the right of the steering column(horn relay and key/headlight buzzer is there too).It drops down similar to the fuse box but you have to remove the whole underdash panel.Just FYI the hazard flasher is just to the left of this next to the steering colmn.
#3
Senior Member
Thread Starter
Join Date: Oct 2001
Location: Lancaster, CA.
Posts: 642
Likes: 0
Received 0 Likes
on
0 Posts
Car: '92 Camaro RS
Engine: 355 TPI
Transmission: Tremec T-56
Axle/Gears: 10 bolt/3.42
#4
Supreme Member
Join Date: Jun 2005
Location: Bremerton, WA
Posts: 1,800
Likes: 0
Received 2 Likes
on
2 Posts
Car: 1992 RS / 1989 RS
Engine: 3.1L MFI / Vortec 383 TBI
Transmission: T5 / LS-T56
Axle/Gears: 3.42 open / 3.73 Eaton posi
Since it's both left and right, it probobly is the flasher. The directional flasher for my '92 is secured by a clip mounted to the steering column bracket under the dash - just above the convenience center (fuse panel). The hazard flasher is over next to the center console.
#6
Supreme Member
iTrader: (2)
Join Date: Dec 2005
Location: Beaufort South Carolina
Posts: 1,739
Likes: 0
Received 4 Likes
on
4 Posts
Car: 1983 Camaro Z/28
Engine: LU5 305 CFI
Transmission: 700R4
Axle/Gears: J65/G80/G92-3.23
That's great you got them working.I knew there were wiring changes after '88.And on the locations of the flasher units in your '92 they moved other items around.
#7
Junior Member
Join Date: Aug 2011
Location: Tennessee
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1992 Camaro
Engine: 305 tbi
Re: turn signal flasher
I have a 92 camaro 305 rs and my right blinker doesnt work. ive changed the bulbs, and the lights work just it doesnt flash. my passenger side turn signal bulb is hanging down to where i can see it does it need to go in the lamp part for it to flash? or do i need to replace the flasher?
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
MikkoV
TPI
2
09-09-2015 04:25 PM
83 Crossfire TA
Suspension and Chassis
0
09-08-2015 12:06 PM