ElectronicsNeed help wiring something up? Thinking of adding an electrical component to your car? Need help troubleshooting that wiring glitch?
Welcome to ThirdGen.org!
Welcome to ThirdGen.org.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
Im am in the process of rebuilding my 305, The engine has been bored 0.040" over, Bigger Cam .472 Intake and .496 Exhaust, 1.6 Rockers, Performer Intake, and Aluminum Heads w/58cc chambers. Not Sure what Carb to use yet. Anyway, As far as ignition goes I have replaced the HEI Coil with an MSD Coil. I have Purchased an MSD 6AL Box, and an MSD Ignition Module that replaces a 4 Pin module and I have a 7 Pin Module I was wondering if this 4 Pin Ignition Module will work or not. And will the 6AL be worth using or should i just not even bother and just use the stock ignition controls? The Distributor is mechanical advance. Thanks for any Info ........
Well I know for sure i dont have Vaccum Advance. But There is a 7 pin module in the distributor. 2 pins on one side with one connector and 5 on the other side with 2 connectors.
If you have a 7 pin module, then you don't have mechanical advance. A mechanical advance distributor woule have a 4 pin module.
The 6AL won't make any difference over a properly working stock ignition.
That is what I have been told too. Save the money. My stocker works fine.
__________________
88 Camaro IROC Z28 Convertible
92 Camaro RS 25th Anniversary 2nd place Best Interior-'09 3rd Gen Fest 1st place Best Interior-'08 3rd Gen Fest 3rd place Camaro Modified-'08 3rd Gen Fest
