06-27-2009, 04:30 AM
|
#1 |
| Junior Member
Join Date: Jun 2009 Location: Mukwonago, WI
Posts: 43
Car: 1989 Camaro RS Engine: 305 for now Transmission: 700r4 Axle/Gears: stupid open diff. 2.73 i think | Wiring Schematic for Switches
ok, so i was bored with nothing to do, so i decided to draw up a wiring diagram for installing switches and keyless start and shaved doors. i didn't add in the wireless controller for the shaved doors, i forgot. i'm not putting it in for now cause i just spent quite some time getting rid of the watermark from my program. stupid thing puts in a watermark over quite a bit of stuff if exporting it to jpeg. the battery is in the trunk (cause thats where mine is going). i didn't label the "motors" or anything, but i'm sure u can figure it out. the switches are as follows from left to right. push button start, main power, fuel pump, ignition, fan override, accessorys (radio and all that) drivers window, pass. window. hope this helps someone tryin to figure out how to wire up switches for everything. this is for a non computer engine and no vats.
disclaimer, this is for guidance only, its is your responsibility to make sure all wiring is done properly.
thanks, for looking | | | |
 
|  |
