ElectronicsNeed help wiring something up? Thinking of adding an electrical component to your car? Need help troubleshooting that wiring glitch?
Welcome to ThirdGen.org!
Welcome to ThirdGen.org.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
First, remove ground wire from battery. Look inside under the passenger side of the dash. Remove two small screws that hold up ECM and it should drop down. There is a small cover plate on ECM with two small screws. Remove and you will see the chip. Remove chip with small flat screwdrive snapping up at each end, easy-ly. Notice how chip is positioned, install new chip. Return ECM to position under dash. Re-hook ground wire to battery. Start engine and let idle for a couple minutes. Raise RPM to about 2500 RPM for about a minute. Take car for a cruise for about ten to fifteen miles for computer to start relearning you. 'Good truckin'....
PS...I think Hypertech sends instructions with chip.
That's my story & I'm sticking to it.
how much HP do you gain and what is the benefits of purchasing a performance chip. I found a stage 1 performance chip from performance chips direct for 69 bucks. Is it worth it?