Issue with Nordskog Digital Gauge - Third Generation F-Body Message Boards

Excellegions · 09-12-2009, 07:24 AM

Hey all

I have the complete digital gauge cluster from nordskog, I got it three years ago. I originally had it in my v6, so the tach was set for a v6, now that Ive dropped a v8 in, I need the tach to be set for a v8. I was suppose to have a lifetime warranty on it but ive tried for two weeks and cannot get them on the phone; just always rings busy, and they dont resond to email. Is there anything out there that I can put between the tach wire so that the v6 tach can read a v8? Or does anyone have any other numbers to contact nordskog??

This ad is not displayed to registered members.
Register your free account today and become a member on ThirdGen!

NINÅ · 09-17-2009, 11:33 AM

On some unit’s a jumper needs to be installed.

What is the model number of yours?

Happy Racing!

If People Drove Any Slower They’d Be Going Backwards

Fog lights are not driving lights. They look dorky. Turn em off slow pokes.

How bout those dorks too scared to drive without headlights on in the daytime!

.
.

Excellegions · 09-17-2009, 12:28 PM

I have the DP4005 - the one that goes to 90 - 92 camaro.

NINÅ · 09-22-2009, 01:54 PM

On the circuit board, below the tach readout, you should see the letters RPM.

Below that you should see 2 jumper wires, one that has been cut.

Reconnect the cut jumper.

You are now good to go with your V8.

Happy Racing!

If People Drove Any Slower They’d Be Going Backwards

Fog lights are not driving lights. They look dorky. Turn em off slow pokes.

How bout those dorks too scared to drive without headlights on in the daytime!

.
.