LQ4 stand alone wiring harness - Third Generation F-Body Message Boards

ironcladwelding · 09-13-2009, 12:47 PM

Help! I have a 1987 Trans Am with a 6 litre LQ4 motor with a stand alone wiring harness. Can anyone help me hook fuel pump relay from '87 Trans Am so it'll work?? I can get fuel pump to pump fuel only by hot wiring it. Doesn't work through the relay. Can I use the stock relay or is there an after market relay and pressure switch that I can use to shut off fuel pump? I have one wire coming out of the OBD II that says fuel enable. Where would I hook that up??? I'm clueless. Any info would be appreciated!! Joe

1ADan · 09-25-2009, 05:03 PM

Welcome!

not trying to pass the buck, but you'd probably get a better answer to this one over in the LTx/LSx engine swap section of the forum.

Stephen · 09-25-2009, 05:53 PM

Your fuel pump relay shouldn't have anything to do with the wiring harness itself. All the relay really needs is key on/off power.

IIRC, I don't think the wiring for it, is even in the engine compartment at right, so I dunno why yours would have stopped working.

ironcladwelding · 09-26-2009, 07:30 AM

Quote:

Originally Posted by Stephen

Your fuel pump relay shouldn't have anything to do with the wiring harness itself. All the relay really needs is key on/off power.

IIRC, I don't think the wiring for it, is even in the engine compartment at right, so I dunno why yours would have stopped working.

thanks for the info got fuel pump relay to work still don't know what red wire is for comeing from harness