Transmission Crossmember - Third Generation F-Body Message Boards

Pistol Pete · 09-08-2009, 09:59 PM

I was told that a TH200 Automatic Transmission Crossmember is what
i need.
Does anybody have one of these, it should have came from a 2.8 6 cylinder motor.

If you have one, can you measure the lenght for me so i know it's
long enough where it would work for me.

Thx

Pistol Pete

This ad is not displayed to registered members.
Register your free account today and become a member on ThirdGen!

Steve86TA · 09-09-2009, 01:47 PM

What are you trying to do/install?

Pistol Pete · 09-09-2009, 02:16 PM

Yes, i'm trying to install a crossmember.

wesilva · 09-11-2009, 06:36 PM

If you are trying to install a 200 4R, you can use an aftermarket crossmember for a Turbo 400. You will have to purchase something that either mounts the stock torque arm or a crossmember/torque arm combination. There is no provisions on a 200 4R for a torque arm to mount.

livewire · 09-13-2009, 11:29 PM

if you mean the TH200c that was on the early third gens I have one from an 82 for 20 + shipping.

vasquezmrysvll · 09-14-2009, 11:16 AM

sorry for hijacking, but will the 82' 200c crossmember work with the 82' t-10 4 speed?

Randy82WS7 · 09-15-2009, 07:23 PM

82 was a one year bolt pattern on the ends of the crossmember

83-up changed bolt pattern on subframes

i have an 82 factory 200c car

350 trans is easiest to install in the 200c cars

and is what i did.

still confused on what you have and what youre trying to install

if you have an 83-up then you need an 83up x member

83 also had a 200c

you dont HAVE to have a certain anything

a flat piece of steel with two holes drilled in it for the trans mount will work fine

back of the trans is light. only need the x member to keep the trans in place