You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
I still have this engine sittin here. The bottom end is stock, but was probably rebuilt at some point because it is clean! The bearings all looked good, no old oil in it, or carbon build up. I put a new oil pump and pan gasket on it. Oil pressure never went below 25psi even when at 200* (which is the hottest it ever got)
A set of Trick Flow Kenny Duttweiler #TFS-30400003 heads are still on it. They've been pocket ported and bowl blended. I have the Trick Flow chromemoly 7.25" pushrods. GMPP head bolts and Ultra Seal head gaskets. Less than 1K miles on them!
$1250 for all. $800 for the heads and pushrods. $450 for the bottom end.
Pickup only, except for the heads. Those I can mail at buyers expense
Youngstown, Ohio
Last edited by Shake Zula; 06-29-2006 at 12:53 PM.
