You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
BBS Designs Single Turbo race manifold - Purchased this earlier this year when he was making them again. Never been installed or ran, only taken out of the box to look at. $500
Ebay BBS Knock Off - This is the ebay setup that mimics the BBS designs header. I picked this up basically for the drivers side manifold and the crossover. Comes with the drivers side manifold, crossover, passenger side manifold, and gaskets. Also never used, I'm going in a different direction. Don't remember how much they're going for, so $250?
2 .60/.63 Turbocoupe T3s. One is still intact, the center housing seems to be good, with minimal shaft play. The other is torn apart, the bolts snapped off in the exhaust housing and will need to be drilled out and probably re-tapped. Have a new center housing for this one. Also have two C4 Vette stainless manifolds. Was going to use these for a twin turbo setup, but had clearance issues (G-body, from pictures I've seen they fit better in an F-body). Make me an offer.
87 TPI base, runners, plenum and fuel rails. The base was port matched to a Fel-Pro 1205 gasket and siamesed 2.5". Plenum was ported, stock runners. Make me an offer.
I'm not really sure how much the TPI stuff goes for now days, $50? The ebay headers look pretty much exactly like the old BBS setup. I'll get some pictures of this stuff this weekend and get it sent out to you guys.
Hi, just a long shot. . . Just wondering if you already sold your turbo exhaust stuff. The BBS turbo header and the E-Bay single turbo kit? If you still have them, please reply to me at parrot-guy@hotmail.com Thanks. Phillip.
