350 engine block
#1
Member
Thread Starter
Join Date: Jun 2005
Location: Tucson, AZ
Posts: 217
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 GTA
Engine: L98 350
Transmission: Swapped to a T-5
Axle/Gears: 3.27
350 engine block
Asking $150 for it I was going to build it up but I crashed my car 4 years ago and it has been sitting around doing nothing. Its a 2 piece rear main seal 4" bore 2 bolt main. The numbers on the front of the block shows that it has high nickel content and that makes it stronger. Block # 3970010
I also have connecting rods I got off ebay for $25 and a stamped oil pan that I'll let go with the connecting rods. I'm asking $25 for them.
The engine block needs machining and a real good cleaning with brushes. The connecting rods I don't know if they are any good, they have not been looked over by a professional. I am only asking for what I paid for the stuff and will be sold as is. Buyer pays for shipping unless they want to pick it up. I'm located in Tucson AZ.
Picture's are at this link https://www.thirdgen.org/forums/sout...lock-sale.html
I also have connecting rods I got off ebay for $25 and a stamped oil pan that I'll let go with the connecting rods. I'm asking $25 for them.
The engine block needs machining and a real good cleaning with brushes. The connecting rods I don't know if they are any good, they have not been looked over by a professional. I am only asking for what I paid for the stuff and will be sold as is. Buyer pays for shipping unless they want to pick it up. I'm located in Tucson AZ.
Picture's are at this link https://www.thirdgen.org/forums/sout...lock-sale.html
Thread
Thread Starter
Forum
Replies
Last Post
theshackle
Tech / General Engine
4
03-05-2017 06:37 PM