You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
Everthing OBO and +shipping. I will entertain any serious offer!
$575 Ported Pro-topline 180’s
Less than 10k miles since professional port work and valve job 280/202 cfm at .6 lift. Springs set up for 135lb seat pressure so good for flat tappet or roller hydraulic lifters. The are not pro-comps or some other Chinese casting. The iron heads never had the problems the aluminum ones did. Will include the once used head bolts and +.100 chromoly pushrods. SOLD
$750 408 short block .040 over block, eagle crank, ohio crank 4340 rods, Ross -20cc pistons. Motor has less than 10k miles on it. Main bearings are shot, but I caught it right away. Original hone is visible, just needs cleaned, crank polished and then new bearings and rings.
$100 Serpentine acessories and brackets for thirdgen. Underdrive crank pulley, polished alternator(was a reman before I polished by hand, not a cheapo chrome unit) water pump has been replaced as well.SOLD
$20 SBC Stock starter for 158 tooth flywheel
$50 Mini Starter unsure of brand SOLD
$80 Cam Motion Blower/EFI Nitrous Grind Cam 235/245 @ .050 .495/.507 on 112LSA. With marked flat tappet lifters.
$50 stock lt1 cam, lifters, springs, pushrods, rockers. SOLD
$50 16x Trickflow Chromoly pushrods 3/8 7.900" length should be +.100 for a SBC, half used for test fitment, half ran for less than 5k miles SOLD
$25 8x 7.900 3/8" pushrods less than 10k miles SOLD
$25 8x 8.000 3/8" pushrods less than 5k miles SOLD
$25 valve stud Girdle for a SBC SOLD
$130 for all or make offer, all come with poly-locks SOLD
8x 1.5 Crane Gold roller rockers, worn
8x 1.5 Lunati roller rockers same as crane's just blue
8x 1.6 Crane gold roller rockers
__________________ -Ryan
1991 Miata Daily driven STS car
1988 Trams Am GTA, LT1/T56 setting up for track days
Last edited by Roostmeyer; 02-08-2009 at 09:46 PM.
Reason: updating
2.02/1.6 the heads are 180cc intakes, they've got some port work in the bowls and port matched to a 1205. Very good flow for the size of runner. The combustion chambers are 64cc.
Also, not sure if I have 24x poly locks for the rockers or just 16.
Last edited by Roostmeyer; 01-20-2009 at 11:47 PM.
