You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
Located in Southwest Missouri. Built 355 SBC with no miles on her at all. 91 L98 block was used for the build. Block was tanked and baked, bored 030 over, and decked. Speed Pro Flat top pistons, moly rings. Eagle crank, rods, clevite bearings, . Melling Hi volume oil pump, LT4 Hotcam .525 .525 219/228, cloyes billet double roller timing set. Pro Street balancer. Fel Pro gaskets. That pretty well sums up the bottom end. All new high quality parts.
$800 I have more than this in just parts.
This ad is not displayed to registered members. Register your free account today and become a member on ThirdGen!
Last edited by jwilliams417; 07-18-2009 at 11:13 PM.
Sponsored Links
Registered users do not see this ad. Click here to register for free!
Re: [MO] Fresh rebuilt 350 roller shortblock w hotcam
I'm interested but would like to know a little more info on the engine. Well first off why you selling it? Secondly did a shop rebuild it or did you personally? Also did you install the hot cam kit or did you peice together your own kit? Are you using roller rockers or the stock 1.5 stamped steel? I guess just tell me everything you can about it. I am within driving distance pretty much. I frequent omaha nebraska quite often which isnt to far depending where in missouri you are.
Re: [MO] Fresh rebuilt 350 roller shortblock w hotcam
The motor was build by a SR ASE tech at Mayse Chevrolet in Aurora Missouri not myself. The LT4 Hotcam was purchased from Summit...just the cam not the kit. I bought 1.6 roller tip rockers to go with it from summit as well. They are summit branded rockers and are for sale here in a seperate thread. Im selling it because Im buying a LS1 that I got an insanely good deal on and need to sell this motor or the wife will murder me. All the machine work on the block was performed by Oreilly Auto parts machine shop in Springfield Missouri...which is where I am located.
Re: [MO] Fresh rebuilt 350 roller shortblock w hotcam
Well i think i may do an LS swap on my car possibly. So good luck with the sale. If anything changes with my plans i'll definately be getting back to you, thanks.
