[NJ] Comp 1.52 Roller Rockers like new - Third Generation F-Body Message Boards

kevinc · 07-22-2009, 05:43 PM

[sold]

anesthes · 07-22-2009, 10:46 PM

Quote:

Originally Posted by kevinc

Set of 16 Comp Cams 1.52:1 ratio roller rockers and poly-locks, with 8 still in the shrink wrap. These are the non-self-aligning model designed for use with guide plates.

We bought this set to test the effect of staggering the ratios, using 1.52 on the intake side and 1.6 on the exhaust side and vice versa. The opened set has only four dyno pulls on them, using synthetic motor oil.

These retail for $322 new, will sell for $150 plus actual shipping cost.

Payment via PayPal or USPS money order only.

3/8" stud?

Shipping to 01841?

-- Joe

kevinc · 07-22-2009, 10:53 PM

7/16" stud, we run big valvesprings and stick with the bigger stud diameter for safety.

Part # is 1304-16 if you want to check the specs.

Comes up as $15.90 shipping, plus insurance if you prefer. Let me know.

wildjyoung · 07-23-2009, 12:11 AM

I am new to engine building so please excuse me if I ask a stupid question. I am looking to purchase TFS-30400006 heads for my build. Would these work with my heads? If so, I will take them assuming the first person does not take them.

Thanks,
Josh

anesthes · 07-23-2009, 06:13 AM

Quote:

Originally Posted by kevinc

7/16" stud, we run big valvesprings and stick with the bigger stud diameter for safety.

Part # is 1304-16 if you want to check the specs.

Comes up as $15.90 shipping, plus insurance if you prefer. Let me know.

Hi Kevin,

I'm using 3/8" studs so I guess that won't work for me without some major upgrading.

Thanks though.

-- Joe

kevinc · 07-23-2009, 07:08 AM

Quote:

Originally Posted by wildjyoung

I am new to engine building so please excuse me if I ask a stupid question. I am looking to purchase TFS-30400006 heads for my build. Would these work with my heads? If so, I will take them assuming the first person does not take them.

Thanks,
Josh

If you specify the heads to be assembled with guideplates and 7/16" studs, these rockers will bolt right on.

anesthes · 07-23-2009, 07:44 AM

Quote:

Originally Posted by kevinc

If you specify the heads to be assembled with guideplates and 7/16" studs, these rockers will bolt right on.

Hrmm.. I was looking at some heads, which apparently it's $80 / pair to upgrade to 7/16" studs.

Let me think about it this morning.

-- Joe

kevinc · 07-23-2009, 08:05 AM

Quote:

Originally Posted by anesthes

Hrmm.. I was looking at some heads, which apparently it's $80 / pair to upgrade to 7/16" studs.

Let me think about it this morning.

-- Joe

It's money well spent going with bigger studs. The mass is static, doesn't affect your valvetrain dynamics.