SBC to LT1 T56 Ram aluminum flywheel - Third Generation F-Body Message Boards

Tunedports1002 · 08-17-2009, 03:24 PM

For sale is a RAM Aluminum internally balanced flywheel for a Small block chevy to lt1 t56 conversion. This was purchased for $470. I am looking to get $335 shipped. I recently added a turbo to my setup which made it overpower my clutch I had. I went to a twin disk setup which requires a different flywheel. Because it overpowered the clutch, it started to slip so the flywheel did get a little hot so some resurfacing may be needed.

ssean92 · 08-17-2009, 03:57 PM

you have to send that one back to get redone if I am not mistaken. I ahve the sameone on my car.

Tunedports1002 · 08-17-2009, 04:13 PM

Now that I think about it you are probably correct. I can tell you though that it did not warp at all. I only had it in there a short time with the turbo on. My truck drove just fine and with out the turbo setup it grabbed great. Didn't really beat on my truck at all to much with this installed. Had a few runs at the track and a little screwing around on the street

ssean92 · 08-17-2009, 05:36 PM

I love mine. good luck with the sale

Tunedports1002 · 08-20-2009, 06:15 AM

Price drpped to $300 shipped