You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
garage cleanout! must go, and looking for parts in trade(UPDATED) LINK TO PICS!!!!!
I have many many 82-92 (few 93-02) camaro and firebird parts from cars ive dissassembled over the years and its time to clean out the garage. including
many interior trim pieces
82-92 camaro fenders $50 each
82-92 firebird drivers side fender $50
85-92 camaro z28 hood with provisions for blisters or louvers (not included) great shape $75
pair of iroc hood louvers, missing tabs so ill let them both go for $40
hatch motors: 1 early style, and 2 92 style $45 each or 50 shipped
blower motors $20 each or 25 shipped
ac delete heater box $ 100 shipped
red lower console $40
manual trans shifter plates $55 shipped
lower trans shifter boots $25 shipped
crossmembers for 700r4 or t5 $25
driveshafts (both stock and aluminum) $40 for a steel shaft/$125 for a aluminum shaft
interior plastics in black and red
4th gen black/grey 4th gen seats. no significant damage, good bolsters, front and rear seats. No front tracks, but you would use your existing tracks from a 3rd or 4th gen as they are the same and are a direct bolt in. Only reason im selling is i bought a set of sparco buckets. Same reason im holding onto the tracks $250/set
clutch pedals for ls1 style t56 $50
89 camaro engine harness, and light harness. basically the complete harness for underhood all the way to the firewall and to the computer $60
87 iroc 305 carb auto ecm $40
89 iroc 305 tbi auto ecm $40
serpentine belt engine brackets $60
ac compressor for serpentine car in working order, no clutch noise $50
smog pump for serpentine car $30
ac condensor with lines for a serpentine car. car had a charge when removed $75
radiator $75
single electric fan assembly $75
camaro drivers side quarter panel complete and no rust $100
seat belt assemblys in black color
lots of under car plastic pieces for the front end
chin spoiler 85-90 z28/iroc/rs style $50
side rocker ground effects 85-90 style rs/z28/iroc $25/side 91-92 z28/rs $30/side
camaro rear bumper covers 85-90 style rs/z28/iroc $50 each 91-92 z28/rs style $60
set of used edelbrock valve covers $20 can have finish sandblasted for additional $10 for perimeter bolt heads
th350 trans mounted torque arm bracket $30
torque arm assemblys $20 for non g92 setup (have holes in center) $50 for g92 solid torque arm with a poly bushing $60
brake master cylinders $25 each
brake boosters $25 each
grid style taillight assemblies $20 each or 35/pr
early style coolant bottle (will work on all) like new (used for less than 200 miles) $20 or $30 shipped
ls1 exhaust manifolds $40
ls1 heads 853 casting with valves and springs, no retainers 30k miles $60
underdash covers and kick panels
low tension hood shocks (good for cowl hoods, or any aftermarket lighter hood) $50
good hatch shocks $40
horns $20 or 25 shipped
fan mounting brackets
tpi lower airboxes $30
fuel doors $10 each
clutch resevoir with hose to master $20
dash bezel covers
6 350tpi injectors $25
oem roller lifters with dogbones and spider $50
front license plate holder $15
rear trunk weatherstripping $20
third brake light assemblies
black sun visors in good shape for a hardtop car (will work in either) fabric not sagging, and they stayed in place in the car $40 or 45 shipped
taillight wiring harness $20
strut mounts $20
tbi/carb air cleaner with hose $30
used firestone firehawk sz50 ep 245/50/16 tire $25
automatic pedal assembly $30 or $40 shipped
ttop glass
wiper motors $25 or $35 shipped
93 z28 150 mph speedo cluster $60
big brake upgrade parts
98-02 front calipers $75 or $80 shipped
firebird/trans am dash map pocket good shape, doesnt hang open $40
2 gold dimpled style gta 16x8 wheels. good shape, no significant damage. Lightest factory thirdgen wheel, perfect for drag radials $125 can ship also
im sure
all pictures can be seen at this link 13 pages of photos
I am not a business, merely a thirdgen fanatic who has personally owned all of the cars these parts have came off of. I have accumulated these parts over the years and its time for them to go so i can have garage room. Im sure there are pieces not listed up there that i have or that i have pictures of. If you dont see it, just ask, alot of the small miniscule stuff is the stuff sometimes forgotten if there is a shipped price, it is for the continetal US only
located on the southside of indianapolis for pickup, can meet or deliver for fuel compensation (reasonable distance), or can ship at buyers expense
Re: garage cleanout! must go, and looking for parts in trade
I'm looking for fuel lines for TPI Speed Density set-up - the two short ones that go up underneath the alternator that connect to the fuel rail. Also needing the mounts that hold the coil that bolt to the intake and distributor hold-down.Zip 72715Thanks!Spun350 !!!! I got the parts that i needed !!!!!!!!!!
Last edited by spun350; 09-16-2009 at 05:40 AM.
Reason: got the parts !!!!
Re: garage cleanout! must go, and looking for parts in trade
I will take the starter, shipping is 11725. i have a 91 rs, i will just need the shifter plate if you have one in really good condition, no cracks or broken tabs.
Re: garage cleanout! must go, and looking for parts in trade
Quote:
Originally Posted by camarorsssss
I will take the starter, shipping is 11725. i have a 91 rs, i will just need the shifter plate if you have one in really good condition, no cracks or broken tabs.
i think it can fit in a large flat rate box so 15 would do it... doesnt matter the weight if it it can fit in the box.
Re: garage cleanout! must go, and looking for parts in trade
all parts that i have pictures of now are available for viewing at the link below. I update this link with new parts every time i snap a pic or sell something.
Re: garage cleanout! must go, and looking for parts in trade(UPDATED) LINK TO PICS!!!
Quote:
Originally Posted by ellocojorge
how much are you asking for the hood blisters shiiped? and do they come with the mounting tabs>
hood blisters are 125. send me your zip code again. shouldnt be too much id say no more than 20 bucks. Yes all the mounting tabs are there and intact. not missing
Re: garage cleanout! must go, and looking for parts in trade(UPDATED) LINK TO PICS!!!
Quote:
Originally Posted by kmann101
Randy I am still looking for door panels how much for the pair of black/ grey cloth shipped up to fort wayne
they arent cheap to ship really, plus you pretty much have to buy a box big enough to ship them in. Since you are closer id think it would be cheaper to get them personally
Re: garage cleanout! must go, and looking for parts in trade(UPDATED) LINK TO PICS!!!
Quote:
Originally Posted by 1b rock
how much for the iroc wheels and hatch motor shipped to 62970 and will you sell two rear wheels or just set
i really dont want to part the set since i have no use for them. i stripped the faces of 3 wheels and was working on the 4. i only want 100 for the wheels.
what year hatch motor do you need? i can get a shipping quote tomorrow
many interior trim pieces
doors $75 each
fenders $50 each
hoods
louvers
blisters
hatch motors
fog lamps
blower motors,
ac delete heater boxes
console
manual trans shifter plates
lower trans shifter boots
crossmembers (both stock and aftermarket for t56 conversion)
driveshafts (both stock and aluminum)
interior plastics in black and red
rear 93-02 camaro firebird seats
clutch pedals for ls1 style t56
door panels
underhood wiring harnesses for carb and throttle body cars
computers
serpentine belt assemblys
ac compressors
smog pumps
ac condensor
radiator
radiator fan assemblys
camaro drivers side quarter panel
seat belt assemblys in black color
lots of under car plastic pieces for the front end
chin spoiler $50
firebird driver fender $50
camaro fenders $50
camaro ground effects (both 85-90 and 91-92)
rear camaro bumper covers (both 85-90 and 91-92)
set of used edelbrock valve covers
tpi throttle bodies
th350 trans mounted torque arm bracket
torque arm assemblys
brake master cylinders
brake boosters
grid style taillight assemblies
washer fluid and antifreeze bottles new and used
ls1 exhaust manifolds
ls1 heads
underdash covers and kick panels
hood hinges
good like new hood shocks
good hatch shocks
horns $15/pr
fan mounting brackets $15
tpi lower airboxes $25
fuel doors $15
clutch resevoir $20
iroc wonderbar $40
dash bezel covers $15
black rear carpet $75
6 350tpi injectors $30
oem roller lifters with dogbones $50
front license plate holder $15
rear trunk weatherstripping $25
third brake light assemblies $20
black sun visors $35
headlight wiring harness $20
taillight wiring harness $20
strut mounts
tbi air cleaner $25
used firestone firehawk sz50 ep 245/50/16 tire
automatic pedal assembly $20
ttop glass
wiper motors $25
15" iroc-z wheels $100
speedometer clusters
big brake upgrade parts
98-02 front calipers $75
wheel spacers
emblems.
LOOKING FOR TWO FRONT DIMPLED GTA WHEELS THAT WOULD BE CONSIDERED IN TRADE FOR THINGS I HAVE!!!
please post up or pm for a price, all parts are ready to be packed and shipped or picked up
thanks guys!
NO PRICE ON THE WHEEL SPACERS ? ARE THEY ALL THE SAME ? SIZE ?
Re: garage cleanout! must go, and looking for parts in trade(UPDATED) LINK TO PICS!!!
You said you only want $100 for the iroc wheels can you check shipping to 90650 i am looking for some if its not too much for shipping i will take them
Re: garage cleanout! must go, and looking for parts in trade(UPDATED) LINK TO PICS!!!
Quote:
Originally Posted by JR350tpi
You said you only want $100 for the iroc wheels can you check shipping to 90650 i am looking for some if its not too much for shipping i will take them
these are also pending pickup tomorrow, if they dont go typically i can get wheels shipped at about 20 a piece
