[TX] 93 M29 T56---freshly rebuilt by Texas Drivetrain Performance
#1
Junior Member
Thread Starter
Join Date: Jun 2009
Location: Austin, TX.
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Car: 93 S10 RCSB
Engine: Corvette LT1
Transmission: 93 M29 T56
Axle/Gears: 8 3/4
93 M29 T56---freshly rebuilt by Texas Drivetrain Performance
I have a 93 M29 Close Ratio T56, it has the same gear ratios as the 2001-2004 ZO6 corvettes. It has been freshly rebuilt to stage 2 specs by Texas Drivetrain Performance in Ft. Worth. It has the bell housing, clutch fork and pivot, & the slave cylinder spacer. I also have a lightly used B&M Ripper shifter with a B&M Hammer T-Handle, a new bronze shifter bushing, and a new stock replacement clutch kit that goes with the trans, and a stock replacement flywheel.
This trans does not have the skip shift solenoid, it was removed from a 93 trans am and was stuck in third gear when i bought it, i thought it was a busted shift fork, but it turned out that one of the synchronizer keys came loose on third gear causing it to be locked in gear. everything else in the trans was very clean, only some slight wear on the main shaft, which TDP welded up the shaft and machined it back down so that the gear/bearing has an actual press fit rather than the factory slip fit.
Any questions, feel free to ask.
Asking 3000 shipped for everything.
This trans does not have the skip shift solenoid, it was removed from a 93 trans am and was stuck in third gear when i bought it, i thought it was a busted shift fork, but it turned out that one of the synchronizer keys came loose on third gear causing it to be locked in gear. everything else in the trans was very clean, only some slight wear on the main shaft, which TDP welded up the shaft and machined it back down so that the gear/bearing has an actual press fit rather than the factory slip fit.
Any questions, feel free to ask.
Asking 3000 shipped for everything.
Last edited by HotRodV6; 03-17-2014 at 07:09 PM.
#2
Member
iTrader: (21)
Join Date: Dec 2001
Location: Texas
Posts: 146
Likes: 0
Received 0 Likes
on
0 Posts
Re: 93 M29 T56---freshly rebuilt by Texas Drivetrain Performance
Just so you guys know Jason at TDP is hands down one of the best shops for manual transmissions and rear ends. People all over the country send their stuff to him. He build them strong and right. Good luck with the sale OP.
#3
Junior Member
Thread Starter
Join Date: Jun 2009
Location: Austin, TX.
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Car: 93 S10 RCSB
Engine: Corvette LT1
Transmission: 93 M29 T56
Axle/Gears: 8 3/4
Re: 93 M29 T56---freshly rebuilt by Texas Drivetrain Performance
Thanks for the props, i did a lot of research on the different T56 builders and TDP was always at the top of the list.
#4
Junior Member
Thread Starter
Join Date: Jun 2009
Location: Austin, TX.
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Car: 93 S10 RCSB
Engine: Corvette LT1
Transmission: 93 M29 T56
Axle/Gears: 8 3/4
Re: 93 M29 T56---freshly rebuilt by Texas Drivetrain Performance
bump ttt, i now have a stock LT1 flywheel and the slave cylinder spacer that will come with the trans. And the clutch comes with ARP pressure plate bolts.
#5
Member
iTrader: (8)
Join Date: Mar 2007
Location: Shreveport Louisianna Barksdale AFB
Posts: 342
Likes: 0
Received 0 Likes
on
0 Posts
Car: 85 Camaro
Engine: forged 383 11:1
Transmission: T56 TDP STAGE 2
Axle/Gears: 99 ws6 3.42 posi rear
Re: 93 M29 T56---freshly rebuilt by Texas Drivetrain Performance
I have my t56 sitting up at TDP right now...been there a year...paid off for awhile...BEST SHOPS for t56 hands down and I paid almost as much as your selling yours just for the build not to mention the trans to begin with and the extra parts....
GOOD DEAL RIGHT HERE
GOOD DEAL RIGHT HERE
#6
Want a title? Post!
Join Date: May 2007
Location: Elizabethton, TN
Posts: 0
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91 RS Camaro
Engine: 305
Transmission: T-5
Axle/Gears: Stock, Motive 373,and Detroit Locke
Re: 93 M29 T56---freshly rebuilt by Texas Drivetrain Performance
do you have pictures how long ago rebuilt
#7
Junior Member
Thread Starter
Join Date: Jun 2009
Location: Austin, TX.
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Car: 93 S10 RCSB
Engine: Corvette LT1
Transmission: 93 M29 T56
Axle/Gears: 8 3/4
Re: 93 M29 T56---freshly rebuilt by Texas Drivetrain Performance
Trending Topics
#8
Want a title? Post!
Join Date: May 2007
Location: Elizabethton, TN
Posts: 0
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91 RS Camaro
Engine: 305
Transmission: T-5
Axle/Gears: Stock, Motive 373,and Detroit Locke
Re: 93 M29 T56---freshly rebuilt by Texas Drivetrain Performance
thanks that sounds good
#9
Member
iTrader: (4)
Join Date: Dec 2010
Location: Virginia
Posts: 122
Likes: 0
Received 0 Likes
on
0 Posts
Car: 88 Iroc Z
Engine: L98 350
Transmission: 700 R4
Re: 93 M29 T56---freshly rebuilt by Texas Drivetrain Performance
Do you have a link for what all is included in stage two? Is it a stock flywheel & clutch?
#10
Junior Member
Thread Starter
Join Date: Jun 2009
Location: Austin, TX.
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Car: 93 S10 RCSB
Engine: Corvette LT1
Transmission: 93 M29 T56
Axle/Gears: 8 3/4
Re: 93 M29 T56---freshly rebuilt by Texas Drivetrain Performance
Here is a link to TDP website, along with the stage 2 build, this one has all new bearings and had the main shaft journal repair, where they weld it then machine it back down so that its an actual press fit rather than the factory slip fit, so it increases strength and durability.
http://www.texasdrivetrainperformanc...hp/t56-6-speed
And, yes, its a stock steel flywheel and stock LT4 style clutch.
#11
Junior Member
Thread Starter
Join Date: Jun 2009
Location: Austin, TX.
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Car: 93 S10 RCSB
Engine: Corvette LT1
Transmission: 93 M29 T56
Axle/Gears: 8 3/4
Re: 93 M29 T56---freshly rebuilt by Texas Drivetrain Performance
bump ttt
#12
Junior Member
Thread Starter
Join Date: Jun 2009
Location: Austin, TX.
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Car: 93 S10 RCSB
Engine: Corvette LT1
Transmission: 93 M29 T56
Axle/Gears: 8 3/4
Re: 93 M29 T56---freshly rebuilt by Texas Drivetrain Performance
bump ttt 2800 shipped is a hell of a deal for a basically bolt in T56 kit minus the hydraulics, which are easy to source.
#13
Junior Member
Thread Starter
Join Date: Jun 2009
Location: Austin, TX.
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Car: 93 S10 RCSB
Engine: Corvette LT1
Transmission: 93 M29 T56
Axle/Gears: 8 3/4
Re: 93 M29 T56---freshly rebuilt by Texas Drivetrain Performance
Bump ttt, willing to sell the extras separately if somebody wants just the trans itself.
#14
Want a title? Post!
Join Date: May 2007
Location: Elizabethton, TN
Posts: 0
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91 RS Camaro
Engine: 305
Transmission: T-5
Axle/Gears: Stock, Motive 373,and Detroit Locke
Re: 93 M29 T56---freshly rebuilt by Texas Drivetrain Performance
Are you still sailing the tran mission I'm look for t56 for my camaro
#15
Junior Member
Thread Starter
Join Date: Jun 2009
Location: Austin, TX.
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Car: 93 S10 RCSB
Engine: Corvette LT1
Transmission: 93 M29 T56
Axle/Gears: 8 3/4
Re: 93 M29 T56---freshly rebuilt by Texas Drivetrain Performance
Yes sir, still got everything. Ready to go.
#16
Want a title? Post!
Join Date: May 2007
Location: Elizabethton, TN
Posts: 0
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91 RS Camaro
Engine: 305
Transmission: T-5
Axle/Gears: Stock, Motive 373,and Detroit Locke
Re: 93 M29 T56---freshly rebuilt by Texas Drivetrain Performance
Ok what are you sale all the parts
#17
Junior Member
Thread Starter
Join Date: Jun 2009
Location: Austin, TX.
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Car: 93 S10 RCSB
Engine: Corvette LT1
Transmission: 93 M29 T56
Axle/Gears: 8 3/4
Re: 93 M29 T56---freshly rebuilt by Texas Drivetrain Performance
I'm asking 2800 shipped for everthing. Which is a very good deal.
Also,if you pay via Paypal it will be plus the 3% fee they charge. Shipping will be via FedEx ground.
Also,if you pay via Paypal it will be plus the 3% fee they charge. Shipping will be via FedEx ground.
#18
Want a title? Post!
Join Date: May 2007
Location: Elizabethton, TN
Posts: 0
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91 RS Camaro
Engine: 305
Transmission: T-5
Axle/Gears: Stock, Motive 373,and Detroit Locke
Re: 93 M29 T56---freshly rebuilt by Texas Drivetrain Performance
??????
Last edited by William Gray; 04-28-2014 at 04:27 PM. Reason: Made Mistake
#19
Junior Member
Thread Starter
Join Date: Jun 2009
Location: Austin, TX.
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Car: 93 S10 RCSB
Engine: Corvette LT1
Transmission: 93 M29 T56
Axle/Gears: 8 3/4
Re: 93 M29 T56---freshly rebuilt by Texas Drivetrain Performance
SOLD, Thanks. Please delete thread.
Thread
Thread Starter
Forum
Replies
Last Post
GeneralIesrussi
Tech / General Engine
0
09-03-2015 03:23 AM