You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
i have a lt1 short block , apart , no spun bearings for 100$ . i am near charlotte nc 4.5 hours to atlanta. mite met ya half way for gas. any 5.7 gta no t top cars for sale in your neck of the woods? any other lt1 parts you need? thanks
I've got my factory 350 block from the 1989 GTA. I'll look to see if it has the hole this afternoon and get a couple of pics of it. Send a couple of pics of the LT1, I've PMed my email address.
it was nice meeting you satuday. i checked out the l98 block this morning and i am very happy with it. i hope you will find the same with the lt1 block. i have alot more lt1 and lt4 stuff if you know any one else looking for any thing. where is a good place to sell my a.i. ported lt4 heads? thanks alot. charlie
Good to meet you too! Anyway, send me a list of everything LT1/LT4 that you have and I'll see what I can do. I need the rear coolant lines from each head. Later, Kevin
Hmmm... I could use some good heads and a matching intake for a stroker LT1 I'm thinking about. Interested in any kind of trading? NOS kits for LT1 or TPI, Comp Pro Mag 1.6RRs, muzzleloaders, USPSA/IPSC unlimited pieces, etc.
i have a set of a.i. or advanced induction lt4 race port heads fresh from the machine shop with comp 977-16 springs and 730-16 titainmum retainers , they have been cut .008 on the deck. i did burn a piston and did some miner dammage but it has been repaired and they work fine. they could have been ran like they were but i had them fixed anyway. with no valves i would take 700$ with valves 950$ , i have almost 3500$ in them. they were 2 tens faster than the afr lt4 heads i had. Advanced Induction - Cylinder Head Development casting 374 lt1 heads by a local porter with stainless valves and comp springs with 3,300 miles 350$ stock 374 lt1 heads 67,000 miles 175$
